Download [PDF] - InventorCAM

MILL-TURN - 2 SPINDLES
The back_spindle_IV.prz example illustrates the use of the InventorCAM
Back Spindle functionality for the machining of the connector part shown
above, on a 5-axis Mill-Turn CNC-Machine.
The following Turning and Milling operations are used to perform the
machining of the part:
• Turning and front side milling (TR_profile; DRILL;
F_profile_1; TR_profile_2)
These operations are used to perform turning and facial milling
of the front faces of the connector. Position #1 of Coordinate
System #1 is used for the operation. The back spindle is not used
in these operations; only the main spindle is used.
• Indexial machining of the middle part
(F_profile_6; D_drill_2; F_profile_7)
These Profile and Drill operations are used to perform the
machining of the pads and holes located around the cylindrical
surface, in the middle part of the connector. Position #5 of
Coordinate System #1 is used for the operation. The Back
Spindle Connect operation is defined before these operations,
enabling the combined use of both spindles (main and back) in
these operations.
42
InventorCAM + Inventor = The Complete Integrated Manufacturing Solution