iS5 English _V2.11__0406 - Back - morek.eu
iS5 English _V2.11__0406 - Back - morek.eu
iS5 English _V2.11__0406 - Back - morek.eu
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 1 – Installation<br />
1.8.1 Wiring Control Terminals<br />
• Wiring Precautions<br />
• CM and 5G terminals are insulated to each other. Do not connect these terminals with each other and do not<br />
connect these terminals to the power ground. Terminal 5G is indicated as CM from 30kW inverters and has the<br />
same potential as CM (Sequence Common Terminal).<br />
• Use shielded wires or twisted wires for control circuit wiring, and separate these wires from the main power circuits<br />
and other high voltage circuits.<br />
• It is recommended to use the cables of 1.25 mm(22 AWG) for connection to the control circuit terminals.<br />
• Control Circuit Terminal<br />
• The control input terminal of the control circuit is ON when the circuit is configured to the current flows out of the<br />
terminal, as shown in the following illustration. CM terminal is the common terminal for the contact input signals.<br />
Resistor<br />
Current<br />
FX<br />
24 VDC<br />
Resistor<br />
RX<br />
CM<br />
External Sequence<br />
Inverter Circuitry<br />
<br />
Do not apply voltage to any control input terminals (FX, RX, P1, P2, P3, JOG, BX, RST, CM).<br />
20
Change language