Practical Industrial Data Networks:Design, Installation and ...

354 Practical Industrial Data Networks: Design, Installation and TroubleshootingImplementation• One RS-232 cable between VAM module and notebook computer• One digital input/output module (part no. 37398)• One proximity detector module (part no. 34016)• One digital output module (4 digital outputs) (part no. 34170)1. Connect up the modules together either with the flat AS-i yellow cable.2. Identify each module clearly.3. Connect computer to the VAM gateway module using an RS-232 cable.4. Be careful about installation of power cable to the gateway.5. Boot up PC and select AS-i tools icon.6. Confirm that lights are illuminated on the AS-i gateway.7. Go to master new and check configuration under communications and ensurethat it is set up for COM 1 standard communications.8. Select file from open file called blank. AS-i (C:\act\demo\)9. Load in file.10. Confirm that the mode switch light is off on the gateway module.11. Download the program to the gateway module by using the downward arrowon the menu.12. Remove the RS-232 cable from the gateway module.13. Click on the mode switch for approximately 15 seconds until the project lightgoes out and observe it scanning the stations on the network.14. Hold down again until the project light goes again.15. The system has now been reset.16. Go to master new and set up comms link appropriately.17. Upload the current status of the network.18. Read the parameter settings and comment on the symbols used under slaves.19. Alternatively, delete everything after assembler and type in the followingsequence:ProgramA I 2.0= Q 1.0***beend.Ensure that the program input and output declarations match up with the originaldeclarations at the beginning of the program.1. Save and download the program.2. Activate the program by setting it to run.3. Confirm program works.4. Modify program and note the effect of an incorrect configuration.Practical 10: DeviceNet installation and configurationObjectives• To show the ease of cabling a DeviceNet system• To configure a simple DeviceNet system