installation and operation manual - Philips Lighting Controls

More documents

Recommendations

Info

INSTALLATION AND OPERATION COMPLI SCENIST II 16Selective Learn Lock (“Designer Presets”)DESCRIPTIONLearn lock is intended to allow “designer presets.” Certain presets can be set by thedesigner or the owner and then locked so they can not be accidentally changed duringnormal use.To AccessHold down PROGRAMPress SETIndication on Rate DisplayProgramPress any PRESET to lock that preset.LOCKED presets will flash.Press again to cancel.ExitSET will return to normal operationEXAMPLELock presets B and C1. Hold Program and press SET2. Press PRESET B3. Press PRESET C4. Press SETChannel ExpansionDESCRIPTIONAny two Compli Scenist II’s can be paired together to double the numberof channels.All pushbuttons will mimic on both panels except CHANNEL UP ANDCHANNEL DOWN. Programming must be done on both Compli Scenist II’s.This section assumes that no other RS-485 network functions are being used.If other RS-485 network functions are being used refer to the Compli Lytemode II Manualfor further information on setting up channels and expanders.ProgramOn Compli Scenist One:Set the ID code to one.Set theexpander code to two.On Compli Scenist Two:Set the ID code to two.Set theexpander code to one.CHANNEL UP increases the ID code.CHANNEL DOWN decreases the ID code.FADE RATE UP selects the Expander code.FADE RATE DOWN selects the ID code.
INSTALLATION AND OPERATION COMPLI SCENIST II 17The ID will be displayed on all bar graphs in binary.ExitSET will return to normal operation.EXAMPLESet up two Compli Scenist II’s for Channel Expansion1. On one Compli Scenist II2. HOLD PROGRAM and press OFF.3. Press CHANNEL 1 UP one time.4. Press FADE RATE UP.5. Press CHANNEL 1 UP two times.6. Press SET.7. On the other Compli Scenist II8. HOLD PROGRAM and press OFF.9. Press CHANNEL 1 UP two times.10. Press FADE RATE UP.11. Press CHANNEL 1 UP one time.12. Press SET.Channel Exclusion from PresetDESCRIPTIONAny channel can be excluded from any PRESET.If a channel is excluded from a PRESET it’s level will not change when that PRESET ispressed.This will allow a single unit to control two rooms with some PRESETS in oneroom, some in the other and some in both.To AccessHold down PROGRAMPress any PRESET but OFFIndication on Rate DisplayProgramPress any Preset to select preset.Press CHANNEL UP to exclude that channel.ExitSet will return to normal operation.EXAMPLEExclude channels 1 and 2 from PRESET B1. Hold PROGRAM and press PRESET B2. Press PRESET B again.3. Press CHANNEL 1 UP4. Press CHANNEL 2 UP5. Press SET
Page 1 and 2: INSTALLATION AND OPERATIONMANUALEll
Page 3 and 4: INSTALLATION AND OPERATIONCOMPLI SC
Page 5 and 6: INSTALLATION AND OPERATION COMPLI S
Page 11 and 12: CONTEMPORARY DISTRIBUTION AND LATE-
Page 15: INSTALLATION AND OPERATION COMPLI S
Page 20: P/N 85-6271

installation and operation manual - Philips Lighting Controls

Create successful ePaper yourself

Delete template?

Save as template?