Electrical Plan Review Submittal Guide / Checklist - City of Bellevue

More documents

Recommendations

Info

control, signal equipment, machine roomcooling/heating, etc.)Fire pumps in low-rise buildings 10 seconds 8 hours913.2 and NFPA20Transformer vault ventilation equipment 60 seconds 4 hoursHeat tape for sprinkler lines and heating insprinkler riser roomsFuel pump system for any legally-requiredsystem60 seconds 24 hours60 seconds 4 hoursSewage disposal pumps 60 seconds 4 hoursTABLE 403(1) FOOTNOTES:1. The fuel pump and associated systems for the emergency or legally required generator shall be provided with powerfrom the generator to maintain fuel supply.FormsCopies of these forms are found on the following pages:Fault Current Calculation FormSample One-Line DiagramSample Single-Phase Panel ScheduleSample 3-Phase Panel ScheduleGenerator Calculation FormSample Fault Current Calculation Summary FormPhotovoltaic System One Line and Spec SheetYour submittal may use our forms, or you may create your own (as long as they are in accordance with ourrequirements), except for large projects that require more extensive fault current calculations.12
Reminders and Notes- The seismic bracing calculations and diagrams by engineering standards submitted to the building reviewerfor equipment between 75 lbs and 400 lbs. at 4’ or more above the floor or roof level, or equipment more than400lbs. at ground level or any height.- NEC 110.16 & NFPA 70E field marked warning labels to warn workers (qualified) of the potential electricflash hazards.- Washington Cities Electrical Code 110.16 A plate or label is required and shall include the flash hazardcategory, the incident energy level in cal/cm(squared) at 18 inches from the flash hazard, and the flash hazardboundary and the date the arc flash calculations were done.- Bellevue Fire Department requires the circuit and control wiring going to the stairway and elevator shaftpressurization fans be separate and protected from all other systems in the building. They are required to beprotected by a 2 hour rated assembly. They shall be separated from the emergency system from the transferswitch (if specific to the pressurization fans) or the first distribution point after the transfer switch to the fans.- Revisions to the original approved plans need to be clouded and dated indicating when the change tookplace. The revisions need to be accompanied by a narrative explaining what the change is particular to eachcloud.13
Page 1 and 2: Electrical Plan ReviewSubmittal Gui
Page 3 and 4: Checklist - Electrical Plan ReviewT
Page 5 and 6: Floor Plan (Lighting)____ Electrica
Page 7 and 8: ____ On a high rise building, if th
Page 9 and 10: Revisions made after Plans approval
Page 11: Smokeproof enclosures and elevator
Page 15: Fault Current Calculation Form, p.2
Page 18: Sample 3Ø Panel Schedule18

Electrical Plan Review Submittal Guide / Checklist - City of Bellevue

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?