UP LS2 LS3 L99 w/4L65E 4L70E 4L80E 4L85E Fuel Injection ...

More documents

Recommendations

Info

The harness has two legs of connectors that run down each side of the fuel rail. Look atthe harness to locate the leg that includes the driver side coil connector along with the 4gauge red charge wire. This leg is to be routed along the fuel rail of the driver side ofthe engine. Do the same for the other leg of the harness for the passenger side.17
Making the Harness Connections:At the harness breakout now located at the center-back of the intake manifold you willfind two black/white wires with ring terminals on them. These are the ground wires forthis harness. They need to be grounded to opposite side heads of the engine. Do thisby using 10 x 1.5mm bolts and lock washers.18
Page 1 and 2: Wire Harness InstallationManual #90
Page 3 and 4: TABLE OF CONTENTSINTRODUCTION ….
Page 5 and 6: o Gear ratios and tire diameters ar
Page 7 and 8: alternator and power steering pumps
Page 9 and 10: Disconnect battery cables from theb
Page 11 and 12: Alternators and Charge Wires:Built
Page 13 and 14: Electronics and Heat Don’t Get Al
Page 15 and 16: Mounting the Fuse Block:This fuse b
Page 17: Harness Routing:Now that the ECM, T
Page 21 and 22: In the parts kit you should find se
Page 23 and 24: On the driver side of the engine bl
Page 25 and 26: NOTE: Don’t forget about the inli
Page 27 and 28: Route the throttle body connector o
Page 29 and 30: Electric Cooling Fans:This 60524 ha
Page 31 and 32: Transmission Connections:Depending
Page 33 and 34: Oxygen Sensors:This harness utilize
Page 35: Accelerator pedal: Pictured below i
Page 38: Fuse block through hole template:Cu

UP LS2 LS3 L99 w/4L65E 4L70E 4L80E 4L85E Fuel Injection ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?