UP LS2 LS3 L99 w/4L65E 4L70E 4L80E 4L85E Fuel Injection ...

More documents

Recommendations

Info

Move back up to the top of the engine. Route the large harness breakout that includesthe passenger side injectors, coils, throttle body, m.a.p. sensor and m.a.f. sensorconnectors down the fuel rail. Plug the injector connectors into their mating injector.The injector connectors are numbered and broke out where they should easily fall rightinto place.Next plug in the passenger side coils connector into the coil sub harness.25
Route the throttle body connector over to the throttle body. Plug it in as shown below.Route the m.a.p. sensor connector up to the m.a.p. sensor, which is located front andcenter top of the intake manifold. Plug it in as shown here.26
Page 1 and 2: Wire Harness InstallationManual #90
Page 3 and 4: TABLE OF CONTENTSINTRODUCTION ….
Page 5 and 6: o Gear ratios and tire diameters ar
Page 7 and 8: alternator and power steering pumps
Page 9 and 10: Disconnect battery cables from theb
Page 11 and 12: Alternators and Charge Wires:Built
Page 13 and 14: Electronics and Heat Don’t Get Al
Page 15 and 16: Mounting the Fuse Block:This fuse b
Page 17 and 18: Harness Routing:Now that the ECM, T
Page 19 and 20: Making the Harness Connections:At t
Page 21 and 22: In the parts kit you should find se
Page 23 and 24: On the driver side of the engine bl
Page 25: NOTE: Don’t forget about the inli
Page 29 and 30: Electric Cooling Fans:This 60524 ha
Page 31 and 32: Transmission Connections:Depending
Page 33 and 34: Oxygen Sensors:This harness utilize
Page 35: Accelerator pedal: Pictured below i
Page 38: Fuse block through hole template:Cu

UP LS2 LS3 L99 w/4L65E 4L70E 4L80E 4L85E Fuel Injection ...

Create successful ePaper yourself

Delete template?

Save as template?