UP LS2 LS3 L99 w/4L65E 4L70E 4L80E 4L85E Fuel Injection ...

More documents

Recommendations

Info

Fuse block through hole template:Cut this template out and use it to mark where your cuts are made in order to throughholemount the fuse block. The template is to scale. After marking your material to becut make sure to cut the line or even 1/16” over the line on the outside of the shadedarea. Otherwise you may need to file to fit the fuse block in the cut hole.37
Page 1 and 2: Wire Harness InstallationManual #90
Page 3 and 4: TABLE OF CONTENTSINTRODUCTION ….
Page 5 and 6: o Gear ratios and tire diameters ar
Page 7 and 8: alternator and power steering pumps
Page 9 and 10: Disconnect battery cables from theb
Page 11 and 12: Alternators and Charge Wires:Built
Page 13 and 14: Electronics and Heat Don’t Get Al
Page 15 and 16: Mounting the Fuse Block:This fuse b
Page 17 and 18: Harness Routing:Now that the ECM, T
Page 19 and 20: Making the Harness Connections:At t
Page 21 and 22: In the parts kit you should find se
Page 23 and 24: On the driver side of the engine bl
Page 25 and 26: NOTE: Don’t forget about the inli
Page 27 and 28: Route the throttle body connector o
Page 29 and 30: Electric Cooling Fans:This 60524 ha
Page 31 and 32: Transmission Connections:Depending
Page 33 and 34: Oxygen Sensors:This harness utilize
Page 35: Accelerator pedal: Pictured below i

UP LS2 LS3 L99 w/4L65E 4L70E 4L80E 4L85E Fuel Injection ...

Create successful ePaper yourself

Delete template?

Save as template?