Bid Document for Hawkers Rehab Centre in Digha.pdf - Integrated ...

More documents

Recommendations

Info

1.6 Qualifications and experience of key personnel proposed for administration and execution of the Contract.Attach biographical data. Refer also to Sub Clause 4.3 (e) and 4.5 (B) (b) of instructions to Bidders and SubClause 9.1 of the Conditions of Contract._______________________________________________________________________________________Years of Years of experience inPosition Name Qualifications experience the proposed position(general)_______________________________________________________________________________________Project Manager * * * ** * * * ** * * * ** * * * *etc._______________________________________________________________________________________1.7 Proposed subcontracts and firms involved. [Refer ITB Clause 4.3 (j)]_______________________________________________________________________________________Sections Value of Sub-contractor Experience inof the works Sub-contract (name and address) similar work_______________________________________________________________________________________* * * ** ** * * ** ** * * ** *______________________________________________________________________________________1.8 Financial reports for the last five years: balance sheets, profit and loss statements, auditors' reports (in case ofcompanies/corporation), etc. List them below and attach copies.1.9 Evidence of access to financial resources to meet the qualification requirements: cash in hand, lines of credit,etc. List them below and attach copies of support documents [sample format attached].1.10. Name, address, and telephone, telex, and fax numbers of the Bidders' bankers who may provide references ifcontacted by the Employer.1.11 Information on litigation history in which the Bidder is involved.__________________________________________________________________________________Other party(ies) Employer Cause of dispute Amount involved Remarks showingpresent status____________________________________________________________________________________________________________________________________________________________________26
1.12 Statement of compliance under the requirements of Sub Clause 3.2 of the instructions to Bidders._____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________1.13 Proposed work method and schedule. The Bidder should attach descriptions, drawings and charts as necessary tocomply with the requirements of the Bidding documents. [Refer ITB Clause 4.1 and 4.3 (k)].2. Joint Ventures - Deleted3. Additional Requirements3.1 Bidders should provide any additional information required to fulfill the requirements of Clause 4 of theInstructions to the Bidders, if applicable.____________________________________________________________________________________________SAMPLE FORMAT FOR EVIDENCE OF ACCESS TO OR AVAILABILITY OF CREDIT FACILITIES –*CLAUSE 4.5 [B] [c] OF ITBBANK CERTIFICATEThis is to certify that M/s. …………………………… is a reputed company with a good financial standing.If the contract for the work, namely …………………………………………………………. [funded by the WorldBank] is awarded to the above firm, we shall be able to provide overdraft/credit facilities to the extent of Rs. …………to meet their working capital requirements for executing the above contract.__ Sd. __Name of BankSenior Bank ManagerAddress of the Bank27
Page 2 and 3: INVITATION FOR BID(IFB)2
Page 4 and 5: TABLE______________________________
Page 6: Section 1: Instructions to BiddersT
Page 9 and 10: (d)(e)The contractor or his identif
Page 11 and 12: B. Bidding Documents8. Content of B
Page 13 and 14: 15.2 In exceptional circumstances,
Page 15 and 16: 20.2 The Employer may extend the de
Page 17 and 18: 29.1 The Employer will evaluate and
Page 19 and 20: 37.1 It is the Bank’s policy to r
Page 21 and 22: SECTION 2:FORMS OF BID, QUALIFICATI
Page 23 and 24: We hereby confirm that this Bid com
Page 25: ** immediately preceding the financ
Page 29 and 30: Letter of Acceptance(letterhead pap
Page 31 and 32: Issue of Notice to proceed with the
Page 33 and 34: In witness whereof the parties ther
Page 35 and 36: Conditions of ContractTable of Cont
Page 37 and 38: The Intended Completion Date is the
Page 39 and 40: 10. Employer’s and Contractor's R
Page 41 and 42: 24. DisputesThe Contractor’s atte
Page 43 and 44: 34.1 If the Engineer-in-charge r in
Page 45 and 46: 44. Compensation Events44.1 The fol
Page 47 and 48: 51.1 The Employer shall make advanc
Page 49 and 50: 60. Payment upon Termination60.1 If
Page 51 and 52: F. Special Conditions of Contract1.
Page 53 and 54: measures, such as Canteens, First-A
Page 55 and 56: discharge of any sewage or trade ef
Page 57 and 58: S.No.ActivityMeasures to be Impleme
Page 59 and 60: SECTION 4: CONTRACT DATA59
Page 61 and 62: ___________________________________
Page 63 and 64: Nature of Advance Amount (Rs.) Cond
Page 65 and 66: SECTION 5: SPECIFICATIONS65
Page 67 and 68: The contractor shall take adequate
Page 69 and 70: 40 IS-814: 1991 Electrodes for manu
Page 71 and 72: 123 IS-1868: 1983 Code of practice
Page 73 and 74: specification. The damp proof cours
Page 75 and 76: The water cement ratio is to be det
Page 77 and 78:
9.1 Frequency of sampling:9.1.1 Sam
Page 79 and 80:
to maintain thinner plaster layer.
Page 81 and 82:
materials. Filling with sand should
Page 83 and 84:
7.5 R.C.C. NP3 pipe:All R.C.C. NP3
Page 87 and 88:
At points where the contour of the
Page 89:
Jointing of D.I. specials with the
Page 93 and 94:
SECTION 7: BILL OF QUANTITIES93
Page 95 and 96:
Chlorophyrofos emulsifiable concent
Page 97 and 98:
contact surface of the frame exclud
Page 99 and 100:
thick sand & cement plaster (1:4) a
Page 101:
) 20 mm dia medium duty Mtrs 40c) 2
Page 105 and 106:
necessary fittings and jointing mat
Page 107 and 108:
RATESL.NO.DESCRIPTION UNIT IN FIGUR
Page 109 and 110:
position and binding with 16 gauge
Page 111 and 112:
222324F25262728293031Anodised alumi
Page 113 and 114:
Supplying & Fixing sheet metal insp
Page 115 and 116:
23 Schedule of rates for installati
Page 117 and 118:
mm. including watering and ramming
Page 119 and 120:
(1:4) cement plaster to inside wall
Page 121 and 122:
Supplying and testing of following
Page 123 and 124:
mm including watering and ramming e
Page 125 and 126:
12 125 mm thick brick work with 1st
Page 127 and 128:
2425G262728Anodised aluminium tower
Page 129 and 130:
89Supplying , fitting & fixing 25mm
Page 131 and 132:
252627E28fixing in position and pai
Page 133 and 134:
On Board Point 568Fixing only fan r
Page 135 and 136:
end of 7/10 SWG GI (Hot Dip) strand
Page 137 and 138:
4142with all necessary accessories
Page 139 and 140:
d) Above 1st Roof Sqm 249.5310Reinf
Page 141 and 142:
232425G262728arrangement both insid
Page 143 and 144:
dia. approved quality PVC waste pip
Page 145 and 146:
75 mm dia each 5.00v) Door Bend (T.
Page 147 and 148:
) Average run 8 mtr Point 60Distn.
Page 149 and 150:
equipments with bolts, nuts, washer
Page 151 and 152:
500W with 300W Halgen )39 Supply of
Page 153 and 154:
filling the space between the brick
Page 155 and 156:
18Supply and installation of local
Page 157 and 158:
slope and jointing with stiff mixtu
Page 159 and 160:
23456(Trench shall be kept dry by d
Page 161 and 162:
5.1 For 2 coreupto 4 sqmm Each 4.00
Page 163 and 164:
34H123if needed (the good earth sha
Page 165 and 166:
245Depth of foundation upto 1500mmE
Page 167 and 168:
direction of the Engineer In Charge
Page 169 and 170:
clearance of 6 mm from wall includi
Page 171 and 172:
Eucalyptus / Jhou bulla pilling shu
Page 173 and 174:
polymerised adhesive (6mm thick lay
Page 175 and 176:
32333435H36coatsSolvent based inter
Page 177 and 178:
a) 300 mm long Each 5b) 450 mm long
Page 179 and 180:
2930E31(A) Above ground(i) 75 mm di
Page 181 and 182:
a)Laying of one no. cable upto 35 s
Page 183 and 184:
28Supplying & Fixing bulkhead light
Page 185 and 186:
c) 1st Floor Cum 3.14d) 2nd Floor C
Page 187 and 188:
181920finish anodised (15 - 18 micr
Page 189 and 190:
cutting pipes, making threads, fitt
Page 191 and 192:
35.56 cm with locking arrangement,
Page 193 and 194:
SL.IN WORDDESCRIPTION UNIT IN FIGUR
Page 195 and 196:
D LANDSCAPING AND PATHWAYS1Earth wo
Page 197 and 198:
all respect with all costs of labou
Page 199 and 200:
15 Supplying and fixing single pole
Page 201 and 202:
5678I123pipes with minimum thicknes
Page 203 and 204:
cement with Super plasticiser per c
Page 205 and 206:
242526quality including smoothening
Page 207 and 208:
CP Pillar cock - 15 mm.13Supplying,
Page 209 and 210:
27work, if necessary, but including
Page 211 and 212:
Schedule of Quantities for Electric
Page 213 and 214:
213
Page 215 and 216:
ANEXURE-DSECTION 8: FORMS OF SECURI
Page 217 and 218:
Annex ABID SECURITY (BANK GUARANTEE
Page 219 and 220:
PERFORMANCE BANK GUARANTEE (for unb
Page 221:
221
show all

Bid Document for Hawkers Rehab Centre in Digha.pdf - Integrated ...

Create successful ePaper yourself

Delete template?

Save as template?