User Manual - Unical Lattner Condensing Hot Water Boilers

Operating instructionsSUMMER TIME.Open the E8 heating controller’s display cover.Turn the rotary knob (F) until the triangle “selected level” (I) ispositioned on DATE/TIME/HOLIDAYIn the SUMMER TIME level it is possible to change, followingthe steps previously described, these values:STARTMONTH>START DAY>STOP MONTH>STOP DAYTo return to the superior level DATE/TIME turn the rotary knob(F) until RETURN is viewed on the display, then press theprogramming key (C).Assistenz aData/Ora/FerieVisualizzareUtenteProgr. TempoTecnic oImpiantoAcqua sanitariaCircuito riscaldamento ICircuito riscaldamento IISolarBy pressing the programming key (C), the TIME-DATE levelwill be displayed.7.3 - USER’s SETTINGSOpen the E8 heating controller’s display cover.Turn the rotary (F) until the triangle “selected level” (I) ispositioned on USER.Turn the rotary knob (F) until the SUMMER TIME level isdisplayed.AssistenzaData/Ora/FerieVisualizzareUtenteProgr. TempoTecnicoImpiantoAcqua sanitariaCircuito riscaldamento ICircuito riscaldamento IISolarPress the programming key (C), the red Change Led will beilluminated (D); at this point it is possible to proceed andchange the values.For several seconds the word USER is viewed on the displaythen the word INSTALLAT will appear.By turning the rotary knob (F) the following levels of the USERarea will be displayed:INSTALLAT>HOT WATER>HEATING CIRCUIT I>HEATINGCIRCUIT II>SOLAR/MFTurn the rotary knob (F) to change the value.INSTALLAT LEVELPress the programming key (C) to pass to the lower level.Press the programming key (C) again (the red Change Led(D) will remain illuminated) to save the adjustment and passon to changing the successive value.By turning the rotary knob (F) it is possible to change thefollowing sub-levels:LANGUAGE>CONTRAST>DISPLAY SEL>RETURN11