User Manual - Unical Lattner Condensing Hot Water Boilers

Operating instructionsAdjustment parameter “BOB—VALUE”By turning the rotary knob (F) you pass onto the successiveparameter “BOB—VALUE”.By pressing the programming key (C), the red Change Ledwill illuminate (D); at this point it is possible to proceed andchange the CIRCL-P parameter.°CBy pressing the programming key (C), the red Change Ledwill illuminate (D); at this point it is possible to proceed andchange the BOB—VALUE parameter.This parameter enables/disenables the running of the DHWcirculation pump.00 = OFF (preset factory value)01 = ON°CThis parameter activates the energy saving function for solaror solid fuel integrations.The temperature can be adjustedfrom 0°K to 25°K0°C = preset factory settingTurn the rotary knob (F) to change the temperature value.Press the programming key (C) again to save the adjustment(the red Change Led (D) will turn off).°CPress the programming key (C) again to save the adjustment(the red Change Led (D) will turn off).Adjustment parameter “ANTILEGION”By turning the rotary knob (F) you pass onto the successiveparameter ANTILEGION.°CAdjustment parameter “CIRCL-P-DHW”By turning the rotary knob (F) you pass onto the successiveparameter CIRCL-P-DHW.By pressing the programming key (C), the red Change Ledwill illuminate (D); at this point it is possible to proceed andchange the ANTILEGION parameter.This parameter enables/disenables the antilegion function.00 = OFF (preset factory value)01 = ON14