User Manual - Unical Lattner Condensing Hot Water Boilers

Operating instructions"DHW” MENUFrom the User’s area, by turning the rotary knob (F), selectthe DHW level on the display.Press the programming key (C) again to save the adjustment(the red Change Led (D) will turn off).AssistenzaData/Ora/FerieVisualizzareUtenteProgr. TempoTecnicoImpiantoAcqua sanitariaCircuito riscaldamento ICircuito riscaldamento IISolarPress the programming key (C) to pass onto the lower level.Adjustment parameter “T—DHW 1”By turning the rotary knob (F) you pass onto the successiveparameter T—DHW 1..°CBy turning the rotary knob (F) it is possible to change thefollowing sub-levels:1X DHW > T—DHW 1 > T—DHW 2 > T-DHW 3 > BOB — VALUE > CIRCL-P-DHW> ANTILEGION >RETURNBy pressing the programming key (C), the red Change Ledwill illuminate (D); at this point it is possible to proceed andchange the T—DHW 1 parameter.°CAdjustment parameter “1X DHW”By pressing the programming key (C), the red Change Ledwill illuminate (D); at this point it is possible to proceed andchange the 1X DHW parameter .This parameter permits the adjustment of the desired hotwater temperature setting.The temperature can be adjustedfrom 10°C to 70°C.60°C = preset factory valueTurn the rotary knob (F) to adjust the desired temperaturevalue.°CThis parameter enables/disenables the charging of aneventual storage tank outside the programmed times.00 = OFF (preset factory value)01 = ONTurn the rotary knob (F) to change the parameter (00 or 01).Press the programming key (C) again to save the adjustment(the red Change Led indicator (D) will turn off).°C13