High Voltage 05, 5G and REDLE K-S Series - Lemo

More documents

Recommendations

Info

® ®Tooling90DCH Spanner for conical nut81.5Part NumberDCH.91.418.0TNø 45● Material: Blackened steel.54DCPSet of flat spanners for collet nuts and round nuts31.130.13.5Part NumberDCP.91.005.TN160● Material: Blackened steel.DCFExtraction tools for HV contactsPart NumberAutomatic modelDCF.91.133.5LTDPHCrimping tool with die and positionerPart NumberApplicationsCablegroupMarking on dieDPH.99.005.2KDPH.99.060.11KDPH.99.065.11Kshieldcentre contactcentre contact1-212DPH.91.005.2KDPH.91.001.16KDPK.91.001.16KNote: DPN Dies and positioner: See 05 series data sheet.Panel cut-out42 min.ø 35.2 + 0.1033.5+ 0.10Recommended mounting nut torque: 7 Nm.12
® ®Termination Instructions Cable Group 1 (multi HT cable)7534FG•617534PH•2245001. Strip the cable according to the given dimensions.A 500 mm length is necessary to give enough flexibilityto the cable.Remove first the outer jacket and the screen then thedielectric of each individual high-voltage conductor,making sure that the cable dielectric is not damaged.3.5 ±0.2 1Dimensions in mm.55552. Slide 2 pieces of 55mm heat-shrink tubing, (not supplied)of the correct size, the clamp collet nut ➀ andthe adapter with cable collet ➁ on the cable.23344AApply laquerCrimpCrimp3. For each individual high-voltage conductor install aHV contact as follow:3.1 Introduce the cable center conductor into the HVcontact ➃ until the conductor end rests against thedielectric and the conductor is visible through thecontact inspection hole. Crimp with the LEMO crimpingtool DPH.99.060.11K. Cover the crimp section ofthe contact and the Peek end of the HV contact witha layer of insulating laquer. Let the laquer dry,approx. 15 min.Note: We recommand the laquer Urethanref: Cellpack n° 912110Apply laquer43Shrink3.2 Slide the heatshrink tube ➂ over the HV contact untilit rests against the contact insulator.One end of the heatshrink tube shall be located at theposition A of the HV contact insulator. Shrink thetube.A43Shrink13
Page 1 and 2: HIGH VOLTAGE CONNECTORSFOR SPECIAL
Page 3 and 4: ® ®05 Series ConnectorsHigh volta
Page 5 and 6: ® ®ModelsFFRStraight plug for cab
Page 7 and 8: ® ®Tooling37DCH Spanner for conic
Page 9 and 10: ® ®Termination Instructions Cable
Page 11 and 12: ® ®Part Section Showing Internal
Page 13: ® ®AccessoriesFFA-ERA HV Contacts
Page 17 and 18: REDEL KftElektronikaK and S Series
Page 19 and 20: REDEL KftMODELSK series (22 contact
Page 21 and 22: REDEL KftACCESSORIESFFA-ERAHigh Vol
Page 24: Headquarter, Ecublens Switzerland

High Voltage 05, 5G and REDLE K-S Series - Lemo

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?