High Voltage 05, 5G and REDLE K-S Series - Lemo

® ®554. Fully introduce the HV contacts into the insulator ➄.– The short insulator shall be fitted with the femaleHV contacts.– The long insulator shall be fitted with the maleHV contacts.Check that the contacts are correctly located andremains in position when given a gentle pull.soldersolder6ground wire L = 130 mmground wire L = 130 mm5. Install a ground wire (not supplied) as follow:5.1 Wrap a tin copper wire 0.5 mm 2 over a 6 mm lengthof the cable screen and hold the ground wire asshown. Then solder.Solder an earthing washer with a 3.5 mm hole on theother side.625ShrinkShrink5.2 Cover the end of the cable screen with the first heatshrinktube and the end of the cable jacket with thesecond heat-shrink tube, then shrink.555525ShrinkShrink55556266. Push the adapter with cable collet ➁ forward over thecable until the insulator locate into the groove on theadapter.Then fit the keyed mid-piece ➅ onto the insulator,make sure that the key of the insulator is correctlylocated into the key of the mid-piece.27 17 17. Next slide the connector shell ➆ over the insulatorassembly making sure that the key on the keyed midpiece goes into the key-way (under the colorpoint/inside the shell).– Note that the HV contact type shall be respecteddepending upon the keying code as indicated onpage 10.Screw the collet nut ➀ and tighten to the maximumtorque value of 4 Nm.Tight the two screws of the adapter and in betweenon an appropriate manner the washer of the groundwire.14