GEA COM4plus - CS Klimateknik

Installation and AssemblyGEA COM4plus5 Installation and AssemblyIn the current chapter you will find information regarding the assembly andinstallation of the unit.The installation may only be carried out by specialists with the appropriate trainingand experience in the relevant accident prevention regulations and otherstandard regulations relevant to health and safety in the workplace,The unit should be installed in such a way that it is accessible only to technicalpersonnel with the appropriate authorisation and training.The unit may only be assembled in accordance with the application shown inthe technical information supplied with the unit.The units must not be stacked with other components that are not part of theunit.The latter is only allowed if the necessary load-bearing capacity has been speciallyincorporated into the units delivered from the GEA works.When connecting the duct it must be ensured that no foreign matter can enter the unit.If necessary, a suitable wire mesh guard can be installed by others at the opening onthe discharge/intake side of the unit.DAMAGE TO THE UNIT!When mounting GEA CompactLine units care must be taken to ensure that noloads are applied on the floor panels. During assembly work suitable measuresshould be taken to ensure that any loads are spread across the bottom profiles(e.g. using grid walkways).5.1 Installation5.1.1 Installation locationThe unit must be installed at a location that fulfils the following requirements:– The substructure must be level and stable.– The maximum deflection of the substructure may not exceed 4 mm per metre.– In units where a condensate drain is installed, the height of the substructure mustbe at least the same as to the required siphon height (see siphon).– Make sure that no damage to the installation location or the environment can becaused by escaping media.Fig. 5-1:Installation location24 PR-2009-0022-GB • Subject to modifications • Status 04/2009