GEA COM4plus - CS Klimateknik

More documents

Recommendations

Info

Electrical ConnectionGEA COM4plus7.2.3 Service switchA lockable main isolator (circuit breaker) installed in the unit switch cabinet can be usedas a service switch. The wiring for service switches installed at the manufacturer’s isled to the motor7.2.4 Installing and connecting actuator motor• If a GEA actuator is pre-installed in the factory, connect the latter in accordance withthe actuator motor data sheet.• If other actuators are used - refer to the relevant documentation.7.2.5 Additional electrical components• Connect additional electrical components in accordance with the relevant provideddocumentation and wiring diagrams.40 PR-2009-0022-GB • Subject to modifications • Status 04/2009
GEA COM4plusCommissioning and Testing8 Commissioning and TestingNOTE!The data sheet and assembly instructions are located on the unit inside in the designatedposition! These documents must be removed prior to the commissioning.Several assembly groups and components must be commissioned separately. The relevantinstructions are listed in the following chapter.DANGER OF ELECTRICAL CURRENT!The following applies for all maintenance and cleaning work: the doors of the unitmay only be opened if the unit has been switched off and it is ensured that the powercannot be inadvertently energized.DANGER OF EXPLOSION RISK AREA!Particular attention must be paid to safety instruction and procedures for (electrical)installation of units operating in explosion risk areas. Failure to comply with theseregulations may result in explosions causing severe personal injury or material damage!DANGER OF ROTATING UNIT PARTSFans do not come to a standstill immediately if the unit is powered down. Beforemaintenance and cleaning you should wait for at least 5 minutes until the fans havecome to a standstill.DAMAGE TO THE UNIT.When mounting GEA CompactLine units it must be ensured that no loads are appliedto the bottom panels. During all installation and maintenance prcocedured appropriatemeasures must be taken to ensure that all load is spread across the bottom profiles(e.g. using grid walkways).Maintenance intervalsThe specified maintenance intervals apply for air with a normal level of contamination.The maintenance intervals must be reduced according to the level of air contamination.NOTE!More intensive cleaning should be carried out in case air contains oil. Sealant materialis oil-proof only for a limited time.Only use alcohol-based disinfectants.PERSONAL PROTECTION!Wear a mask and protective gloves when carrying out cleaning and specified maintenanceof the unit.PR-2009-0022-GB • Subject to modifications • Status 04/2009 41
Page 3 and 4: GEA COM4plusProduct Type Code1 Prod
Page 5: GEA COM4plusSafety and User Informa
Page 8 and 9: Safety and User InformationGEA COM4
Page 10 and 11: Technical DescriptionGEA COM4plus3
Page 12 and 13: Technical DescriptionGEA COM4plusAi
Page 14 and 15: Technical DescriptionGEA COM4plus3.
Page 20 and 21: Transport and StorageGEA COM4plus4
Page 22 and 23: Transport and StorageGEA COM4plus4.
Page 24 and 25: Installation and AssemblyGEA COM4pl
Page 34 and 35: Installation of Components and Acce
Page 36 and 37: Installation of Components and Acce
Page 38 and 39: Electrical ConnectionGEA COM4plus7.
Page 42 and 43: Commissioning and TestingGEA COM4pl
Page 54 and 55: Disassembly and DisposalGEA COM4plu
Page 56: Customer proximity, sales structure

GEA COM4plus - CS Klimateknik

Create successful ePaper yourself

Delete template?

Save as template?