II PRO PLUS Snowplow #64750/64999/66901/66974/66980

INSTALLATION INSTRUCTIONS9. Install the clamp base, double hose clamp,5/16" washer and 5/16" locknut loosely on theweld stud on lower lift frame cross tube near liftram.10. Install a split rubber hose sleeve on each 42" hosejust above the mark made in Step 6.11. Orient clamp and base as shown and install hosesin their respective side of clamp with sleevescentered in clamp and sleeve openings to insideof clamp. Tighten clamp. Final position of clampshould be approximately 20° clockwise fromhorizontal. Proper positioning of the hoses in theclamp is necessary to allow complete movementof the snowplow without stressing the hoses.12. If necessary, realign clamp and fi ttings so hosesdo not contact snowplow frame, mount or vehicle.Approx.20°ClampBase5/16" Washer w/5/16" LocknutDoubleHose ClampHEADLAMPSHeadlamps and hardware are found in the headlampbox. Additional hardware (1-7/8" OD fl at washer) isfound in the hydraulics box.1. With wire harness behind lift frame, attachheadlamps to hole in headlamp channel(not in slot) with headlamp swivel on top and9/16" x 1-7/8" OD fl at washer, 1/2" lock washerand 1/2" locknut underneath.1-7/8" ODFlatWasher(Found inHydraulicBox)1/2" LockWasher1/2" NutHeadlamp SwivelGrommetCable TieAnchorBlack/Orange WireSleeveDriver'sSidePassenger'sSide(+)HeadlampSwivel(–)Cable BootBattery CableBlack/RedBatteryCableBlackBatteryCableHeadlampHarnessLit. No. 66897, Rev. 07 16 June 15, 2010