II PRO PLUS Snowplow #64750/64999/66901/66974/66980

More documents

Recommendations

Info

OPERATIONAL TESTS AND FINAL ADJUSTMENTSBLADE DROP SPEED ADJUSTMENTWARNINGKeep 8' clear of the blade when it is beingraised, lowered or angled. Do not standbetween the vehicle and blade or directly infront of the blade. If the blade hits or drops onyou, you could be seriously injured.QuillThe quill in the top of the valve manifold on thepassenger-side front corner adjusts the blade dropspeed.1. Lower the blade to the ground before makingadjustment. Turn the control OFF.2. Turn the quill IN (clockwise) to decrease dropspeed.Fill PlugDrain PlugTurn the quill OUT (counterclockwise) to increasedrop speed.3. Stand clear of the blade when checkingadjustment.Lit. No. 66897, Rev. 07 20 June 15, 2010
OPERATIONAL TESTS AND FINAL ADJUSTMENTSFINAL INSPECTION AND ADJUSTMENT1. Attach the snowplow to the vehicle mount. Withsnowplow lowered to the ground and on levelpavement, measure the dimension from theground to the center of the pivot bar cap screw.This dimension must be 9-3/4" to 11-1/4".2. With the snowplow attached and on the ground,place the stand arm in the lower position withthe lock pin engaged and with the stand shoefully retracted in the "up" position. Measure thedistance from the ground to the bottom of thestand shoe. This distance should be 1-3/8" to2-1/8". The stand can be adjusted to achieve thisdimension by removing the roll pin and selectingthe proper hole in the stand stem. When the standheight is correct, cut and remove the spring tie.in the tightest possible link. This adjustment willprovide for optimum transport height, blade fl oat,and stacking stop clearance. When chain tensionis correct, the A-frame will not contact the liftframe when the blade is fully raised.4. Fully raise the blade and verify that it does notblock the headlamp beams. If the blade blocks theheadlamp beams, lower the blade to the ground,collapse the lift ram and lengthen each chain byone link. Repeat this process, lengthening thechains by one link each time, until the blade doesnot block the headlamp beams.3. Final lift chain link adjustment must be madeafter the snowplow is assembled with the properpivot plate position. On a level surface with thesnowplow on the ground and the lift ram fullycollapsed, attach the chains to the lift arm hooksRoll Pin(AgainstStand Body)1-3/8" to 2-1/8"9-3/4" to 11-1/4"Lit. No. 66897, Rev. 07 21 June 15, 2010
Page 1: Western Products, PO Box 245038, Mi
Page 4 and 5: SAFETYSAFETY PRECAUTIONSImproper in
Page 6 and 7: INSTALLATION INSTRUCTIONSSNOWPLOW A
Page 8 and 9: INSTALLATION INSTRUCTIONSCHAIN TO A
Page 10 and 11: INSTALLATION INSTRUCTIONS4. Before
Page 12 and 13: INSTALLATION INSTRUCTIONSSTAND1. Po
Page 14 and 15: INSTALLATION INSTRUCTIONSLift RamTh
Page 16 and 17: INSTALLATION INSTRUCTIONS9. Install
Page 18 and 19: INSTALLATION INSTRUCTIONSPLOW BATTE
Page 22 and 23: OPERATIONAL TESTS AND FINAL ADJUSTM
Page 24: Western ProductsPO Box 245038Milwau

II PRO PLUS Snowplow #64750/64999/66901/66974/66980

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?