LTV 1200 Operator's Manual - AARC.org

More documents

Recommendations

Info

NPPV ModeNon-invasive Positive Pressure Ventilation, (NPPV) can be selected as the primary mode ofventilation. In the NPPV mode, the ventilator cycles between IPAP (Pressure Support) and EPAP(PEEP). When a patient trigger is detected, a Pressure Support patient breath is given.WARNINGMasks used with the LTV ® 1200 must be non-vented (no holes or leak vents). With a vented mask,the patient's exhaled air escapes via holes or vents in the mask, elbow or swivel connector. With anon-vented mask, the patient's exhaled air escapes through the ventilator exhalation valve. Using avented mask will deplete the oxygen supply faster, and also may lead to patient-ventilatordysynchrony.Excessive leakage can also occur if the mask is not properly sealed to the patients face.REMARQUELes masques utilisés avec le LTV ® 1200 ne doivent pas être ventilés (ni trous ni épanchements d’air).Avec un masque de ventilation, l’air que le patient expire s’échappe par les trous ou la ventilation dumasque, le coude ou le connecteur pivotant. Avec un masque qui n’a pas de ventilation, l’air que lepatient expire s’échappe à travers la valve d’expiration du ventilateur. Utiliser un masque deventilation va épuiser la réserve d’oxygène plus rapidement et peut aussi causer une dysynchronieentre le patient et le ventilateur.Des fuites excessives peuvent aussi se produire si le masque n’est pas proprement étanche sur levisage des patients.Page 4-4 LTV ® 1200 Ventilator Operator’s Manualp/n 18247-001, Rev. E
Apnea BackupThe LTV ® 1200 ventilator provides an Apnea Backup mode of ventilation. Apnea Backup ventilationbegins when the time since the last breath start is greater than the set Apnea Interval.When an apnea alarm occurs:• If an inspiration is in progress, the ventilator cycles to exhalation.• The ventilator begins Apnea Backup ventilation in the Assist/Control mode according to thecurrent control settings. The active controls are displayed at full intensity, and all other controlsare dimmed.The breath rate for Apnea Backup mode is determined as follows:• If the set Breath Rate is ≥ = 12 bpm, the Apnea breath rate is the set Breath Rate.• If the set Breath Rate is < 12 bpm and the set Breath Rate is not limited by other control settings,the Apnea breath rate is 12 bpm.• If the set Breath Rate is limited to
Page 3 and 4: Document Revision HistoryDocument R
Page 6 and 7: Notice To OperatorsUnsafe Operation
Page 8 and 9: Chapter 6 - Controls...............
Page 10 and 11: LPPS OFF...........................
Page 12 and 13: Chapter 15 - Troubleshooting ......
Page 14 and 15: Operator’s Safety InformationAll
Page 16 and 17: WARNINGBattery run time - When the
Page 18 and 19: AVERTISSEMENTPersonnel non qualifi
Page 20 and 21: AVERTISSEMENTConcentration d’oxyg
Page 22 and 23: CautionsCAUTIONVentilator Steriliza
Page 24 and 25: CAUTIONExternal Battery Pack - The
Page 26 and 27: ATTENTIONNettoyage du panneau front
Page 28 and 29: SymbolsSymbol Compliance 3 Title Ap
Page 30 and 31: Power/Supplies RequiredTo operate t
Page 32 and 33: Page 2-4 LTV ® 1200 Ventilator Ope
Page 34: Volume Control BreathsFor Volume Co
Page 37 and 38: Pressure Support BreathsFor Pressur
Page 39 and 40: Chapter 4 - VENTILATION MODESThe LT
Page 41: CPAP ModeCPAP mode is selected when
Page 45 and 46: Chapter 5 - USING THE CONTROLS AND
Page 47 and 48: ButtonsButton controls do one of th
Page 49 and 50: Flashing ControlsVariable controls
Page 51 and 52: Chapter 6 - CONTROLSThis section ex
Page 53 and 54: Control LockThe LTV ® 1200 ventila
Page 55 and 56: Inspiratory / Expiratory HoldPushin
Page 57 and 58: NOTEThe ventilator will not perform
Page 59 and 60: NOTEThe ventilator will not perform
Page 61 and 62: Low Minute VolumeThe Low Minute Vol
Page 63 and 64: Low Pressure O 2 SourceWhen selecte
Page 65 and 66: Low Pressure O 2 Source (cont)Low P
Page 67 and 68: Manual BreathUse the Manual Breath
Page 69 and 70: O 2 % (O 2 Flush) (cont)ATTENTIONCo
Page 71 and 72: PEEP ControlThe PEEP control establ
Page 73 and 74: Pressure SupportThis control establ
Page 75 and 76: SensitivityUse the Sensitivity cont
Page 77 and 78: Silence ResetUse this button to sil
Page 79 and 80: Volume Pressure ModeUse this button
Page 81 and 82: Chapter 7 - DISPLAYS AND INDICATORS
Page 83 and 84: Battery Level (cont)WARNINGBattery
Page 85 and 86: External PowerThe External Power in
Page 87 and 88: Chapter 8 - MONITORED DATAThis sect
Page 89 and 90: PIP xxx cmH2OThe Peak Inspiratory P
Page 91 and 92: Chapter 9 - VENTILATOR ALARMSWhen c
Page 93 and 94:
BAT EMPTYWhen the ventilator is ope
Page 95 and 96:
BAT LOWWhen the ventilator is opera
Page 97 and 98:
DEFAULTSAll controls and extended f
Page 99 and 100:
DEFAULTS SETThe DEFAULTS SET alarm
Page 101 and 102:
HIGH fWhen the Total Breath Rate (f
Page 103 and 104:
HIGH PEEPWhen the patient circuit p
Page 105 and 106:
High PRES (cont.)The HIGH PRES alar
Page 107 and 108:
INOPAn INOP alarm is generated when
Page 109 and 110:
LOW O 2 PRESWhen the average oxygen
Page 111 and 112:
LOW PRESWhen the peak inspiratory p
Page 113 and 114:
POWER LOSTWhen the ventilator is po
Page 115 and 116:
REMOVE PTNTWhen the ventilator is p
Page 117 and 118:
SBT < fWhen the Spontaneous Breathi
Page 119 and 120:
SBT < f/VtWhen the Spontaneous Brea
Page 121 and 122:
SBT OFFWhen the minutes preset in t
Page 123 and 124:
Alarm Status Messagesf PEEP OFFThe
Page 125 and 126:
LMV OFFThe LMV OFF message is displ
Page 127 and 128:
SBT f/Vt OFFThe SBT f/Vt OFF messag
Page 129 and 130:
Chapter 10 - EXTENDED FEATURESThis
Page 131 and 132:
Alarm OperationsUse the Alarm Opera
Page 133 and 134:
High fUse this menu item to set the
Page 135 and 136:
Vent OperationsUse the Vent Operati
Page 137 and 138:
Variable Flow TerminationUse the Va
Page 139 and 140:
Pressure Control Flow TerminationUs
Page 141 and 142:
O 2 ConserveUse the O 2 Conserve op
Page 143 and 144:
Control UnlockUse the Control Unloc
Page 145 and 146:
Set DateUse the Set Date option to
Page 147 and 148:
PIP LEDUse the PIP LED option to tu
Page 149 and 150:
O 2 Cylinder DurationUse the O 2 Cy
Page 151 and 152:
PresetsUse the Presets section of t
Page 153 and 154:
SBT (Spontaneous Breathing Trial) O
Page 155 and 156:
SBT Operations (cont.)4) Turn the S
Page 157 and 158:
Bi-directional Flow Transducer Diff
Page 159 and 160:
Exhalation Flow Transducer Differen
Page 161 and 162:
DisplayLEAK xx.xx LpmFTw xx.xx Lpmo
Page 163 and 164:
Chapter 11 - VENTILATOR CHECKOUT TE
Page 165 and 166:
Alarm TestUse the Alarm Test to ver
Page 167 and 168:
Display Test (cont)Verify displays
Page 169 and 170:
Control Test (cont)3) Test each con
Page 171 and 172:
Leak Test (cont)5) To perform the L
Page 173 and 174:
Vent Inop Alarm Test (cont)4) For a
Page 175 and 176:
Chapter 12 - OPERATING PROCEDUREThi
Page 177 and 178:
3) If required, connect a low or hi
Page 179 and 180:
Procedure for Assist/Control Mode S
Page 181 and 182:
Procedure for CPAP Mode Set UpSet a
Page 183 and 184:
To Turn the Ventilator Off1) Discon
Page 185 and 186:
Chapter 13 - CLEANING, DISINFECTING
Page 187 and 188:
Cleaning or replacing the Inlet Fil
Page 189 and 190:
3) Using a pick, gently remove the
Page 191 and 192:
CAUTIONCleaning the Water Trap - Do
Page 193 and 194:
For purposes of cleaning or disinfe
Page 195 and 196:
2) Align the tab on the valve body
Page 197 and 198:
Chapter 14 - POWER AND BATTERY OPER
Page 199 and 200:
Using an External BatteryOptional E
Page 201 and 202:
For more detailed information on us
Page 203 and 204:
CAUTIONAutomobile Cigarette Lighter
Page 205 and 206:
4) Verify the ventilator is being p
Page 207 and 208:
The SprintPack Li-Ion Power SystemT
Page 209 and 210:
Chapter 15 - TROUBLESHOOTINGThis ch
Page 211 and 212:
Symptoms Possible Causes What to Do
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Power and Battery OperationProblem
Page 225 and 226:
AlarmsMany alarms such as HIGH PRES
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Checkout Test FailuresSymptoms Poss
Page 235 and 236:
Test Lung OperationsSymptoms Possib
Page 237 and 238:
Appendix A - VENTILATOR SPECIFICATI
Page 239 and 240:
AlarmsVariable AlarmsControl Range
Page 241 and 242:
Mechanical ControlsControl Range To
Page 243 and 244:
Storage and Operating Conditions (c
Page 245 and 246:
Power (cont.)Internal Battery12V se
Page 247 and 248:
Appendix B - SET UP / MAINTENANCERe
Page 249 and 250:
Appendix C - INSTALLATION AND CHECK
Page 251 and 252:
Protective Boot RemovalSupplies/Too
Page 253 and 254:
To Remove the Lower Protective Boot
Page 255 and 256:
• Item (5), #4-40 X 1/4” Flat-h
Page 257 and 258:
Operator’s Manual LTV ® 1200 Ven
Page 259 and 260:
Ventilator without Humidifier1) Con
Page 261 and 262:
For Operation from a High Pressure
Page 263 and 264:
Communications PortThe Communicatio
Page 265 and 266:
3) If the remote alarm has a male B
Page 267 and 268:
Ventilator Settings and ProcedureG)
Page 269 and 270:
Procedure:Set the O 2 % control to
Page 271 and 272:
Appendix D - PRINCIPLES OF OPERATIO
Page 273 and 274:
Appendix E - EVENT TRACEThe Event T
Page 275 and 276:
Event CodesThis section includes a
Page 277 and 278:
Code Event Name Event Associated Al
Page 279 and 280:
Event Name Code Event Associated Al
Page 281 and 282:
Appendix F - GLOSSARYTERMACAirway c
Page 283 and 284:
TERMLEDlpmMachine breathManual brea
Page 285 and 286:
Appendix G - INDEXAAC Adapter · 14
Page 287 and 288:
Ff · 8-2, 8-3f PEEP OFF · 9-33f/V
Page 289 and 290:
SBT LO f OFF · 9-37SBT LOW f · 10
show all

LTV 1200 Operator's Manual - AARC.org

Create successful ePaper yourself

Delete template?

Save as template?