Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Allocating signals to the buttons<br />
f Please follow the operating instructions for the<br />
original hand-held transmitter.<br />
Prior to programming the HomeLink for the<br />
first time<br />
The following process deletes the standard codes<br />
set at the factory. Do not repeat the process if you<br />
program further buttons.<br />
f Keep the two outer buttons 1 and 3<br />
depressed for approx. 20 seconds until lightemitting<br />
diode A begins to flash quickly.<br />
All programmed signals of buttons 1 to 3 are<br />
deleted.<br />
Programming HomeLink with fixed code<br />
hand-held transmitters<br />
1. Press and hold the desired button until the<br />
light-emitting diode begins to flash slowly.<br />
You then have approx. 5 minutes to perform<br />
steps 2 and 3.<br />
2. Hold the original hand-held transmitter approx.<br />
0 to 12 in. (0 to 30 cm) in front of the marked<br />
position (figure) on the vehicle.<br />
3. Press the transmit button on the original handheld<br />
transmitter until the daytime driving lights<br />
flash three times (up to approx. 45 seconds).<br />
4. Repeat steps 1 to 3 to allocate other buttons.<br />
Programming HomeLink with changeable<br />
code hand-held transmitters<br />
1. Press and hold the desired button until the<br />
light-emitting diode begins to flash slowly.<br />
You then have approx. 5 minutes to perform<br />
steps 2 and 3.<br />
2. Hold the original hand-held transmitter approx.<br />
0 to 12 in. (0 to 30 cm) in front of the marked<br />
position (figure) on the vehicle.<br />
3. Press the transmit button on the original handheld<br />
transmitter until the daytime driving lights<br />
flash three times (up to approx. 45 seconds).<br />
4. To synchronize the system:<br />
Press the programming button on the receiver<br />
for the garage door actuator.<br />
Afterwards, you usually have approx.<br />
30 seconds to initiate step 5.<br />
5. Press the allocated HomeLink button twice.<br />
(With some devices, the button to be allocated<br />
must be pressed a third time in order to<br />
complete the setting process.)<br />
6. Repeat the programming steps to allocate<br />
other buttons.<br />
Note<br />
Several attempts with different distances between<br />
the vehicle and the original hand-held transmitter<br />
might be necessary.<br />
The daytime driving lights will flash once the 5<br />
minutes have been exceeded. Programming must<br />
be repeated from the beginning.<br />
f Please consult your authorized Porsche dealer<br />
if you have not been able to successfully<br />
allocate signals for the garage door opener to<br />
the buttons even though you have carefully<br />
followed the instructions in this chapter and<br />
the operating instructions for the original handheld<br />
transmitter.<br />
Deleting programmed signals of the<br />
HomeLink<br />
(e.g., when selling the vehicle)<br />
Keep the two outer buttons 1 and 3 depressed<br />
for approx. 20 seconds until light-emitting diode A<br />
begins to flash quickly.<br />
All programmed signals of buttons 1 to 3 are<br />
deleted.<br />
Operation, Safety 107