TVG420 User Manual 2.2 (SW release 1.2.2)

More documents

Recommendations

Info

$F:\ENG_DOCS\Datasheets Corel Originals\Pt-hp-s2 Rev D.cdr$

ASI-IP-GTW User's ManualThis will result in the IP address 10.40.80.100. The subnet mask is setto 255.255.255.0 and the default gateway to 10.40.80.1.3.3 Looking at the WEB interfaceFigure 7 shows the Status page of the WEB-based user interface to theequipment.Figure 7. The overall status pageOverall status: The top part of the page is the same for all pages. Thetype name of the product is given. In the upper left corner two bars arepresented. The first is the progress bar which will show the progress ofan action started, e.g. the download of a new parameter set. Theactivity bar will light every time the computer is requesting or sendingdata to the ASI-IP-GTW. Under normal operation, the activity bar shalltwinkle regularly.Main menus: The WEB-based user interface of the ASI-IP-GTW consistsof the following main pages: Status, Device Info, IP TX/IP RX, Networkand Save/Load. Some of the main pages have a number of sub-pages.The following table gives an overview of the different pages.Page 26
ASI-IP-GTW User's ManualMain tab (page) Sub-tab DescriptionStatusDevice InfoIP TXIP RXNetworkSave/LoadCurrent alarmsAlarm logNetworkTime settingsAlarmsSNMPPingSecurityRIP-2MainFECEthernetPingMainFECEthernetPingAdvancedThe current status of the unit is shown. The pageshows pending alarms together with informationabout when the alarm appeared and the severity levelof the alarm.The alarm log shows past alarms. Current alarms arenot shown on alarm log.This gives information about the serial number andsoftware version of the unit. In addition, the user canassign a name to the unit. The user can also changethe operation mode (IP Transmit , IP Receive or both)or manually reset the device from this page.This is where IP address, subnet mask and defaultgateway is defined for management interface anddata interface. In addition, for the data interfaces, theAdvanced tab provides configuration of in-bandmanagement. The SFP tab provides informationabout the SFP.Set SNTP server address. Current time is shown ifvalid SNTP server is already defined.Provides a list of all alarms and configuration ofseverity level for the alarm events.Set Trap Destination Servers.A page offering an interface to check for connectivityby pinging a remote host.Enable or disable password protection, and changepassword.Show status, and change parameters for the RoutingInformation ProtocolThis is where each input is configuredThis is where the main parameters of each input areconfigured. In addition, status of each stream isshown.This is where the FEC parameters are configured.This is where VLAN tagging, and Static MAC isconfigured.This is where Ping parameters for the IP channel isconfigured.This is where the outputs are configured.This is where the main parameters of the outputs areconfigured.This is where the FEC parameters are configured.This is where VLAN tagging, and Static MAC isconfigured.This is where Ping parameters for the IP channel isconfigured.Advanced parameters related to buffer regulator.Overview of IP addresses UDP ports and bitrates.Save and load of configurations.To select a page, just click on the tab of the page you want to view.Page 27
Page 1 and 2: Flashlink User ManualASI-IP-GTWDVB-
Page 4 and 5: ASI-IP-GTW User's ManualPage 4
Page 7 and 8: ASI-IP-GTW User's Manual6.4.2 Preli
Page 9 and 10: ASI-IP-GTW User's ManualCaution: Ca
Page 11 and 12: ASI-IP-GTW User's ManualoooooType o
Page 13 and 14: ASI-IP-GTW User's ManualNote: Some
Page 15 and 16: ASI-IP-GTW User's Manual2 Installin
Page 17 and 18: ASI-IP-GTW User's ManualGTW are no
Page 19 and 20: ASI-IP-GTW User's ManualWarning: If
Page 21 and 22: ASI-IP-GTW User's Manual2.4 Signal
Page 23 and 24: ASI-IP-GTW User's ManualTable 7. Op
Page 25: ASI-IP-GTW User's Manual3 Operating
Page 29 and 30: ASI-IP-GTW User's Manual3.5 Device
Page 31 and 32: ASI-IP-GTW User's Manual1.1.1.21 Ad
Page 33 and 34: ASI-IP-GTW User's Manual3.5.2 Time
Page 35 and 36: ASI-IP-GTW User's ManualFigure 13 S
Page 37 and 38: ASI-IP-GTW User's Manualpressing th
Page 39 and 40: ASI-IP-GTW User's Manual3.6 IP TXFi
Page 41 and 42: ASI-IP-GTW User's ManualType of ser
Page 43 and 44: ASI-IP-GTW User's ManualResulting t
Page 45 and 46: ASI-IP-GTW User's Manual3.6.4 Ping
Page 47 and 48: ASI-IP-GTW User's Manual1.1.1.28 Ou
Page 49 and 50: ASI-IP-GTW User's ManualMax frames
Page 51 and 52: ASI-IP-GTW User's Manual3.7.4 Ping
Page 53 and 54: ASI-IP-GTW User's ManualMax bitrate
Page 55 and 56: ASI-IP-GTW User's ManualFigure 26 s
Page 57 and 58: ASI-IP-GTW User's ManualFigure 28.
Page 59 and 60: ASI-IP-GTW User's Manualo 1PPS. 50
Page 61 and 62: ASI-IP-GTW User's Manual4.2 RIPv2 f
Page 63 and 64: ASI-IP-GTW User's Manual5 Equipment
Page 65 and 66: ASI-IP-GTW User's ManualThe WEB int
Page 67 and 68: ASI-IP-GTW User's Manual5.3 Overvie
Page 69 and 70: ASI-IP-GTW User's Manual11 Media pa
Page 71 and 72: ASI-IP-GTW User's ManualThe warrant
Page 73 and 74: ASI-IP-GTW User's Manual6.4.4 Fan(s
Page 75 and 76: ASI-IP-GTW User's Manual6.5 Disposi
Page 77 and 78:
ASI-IP-GTW User's Manualformat. Thr
Page 79 and 80:
ASI-IP-GTW User's ManualUnicast: Po
Page 81 and 82:
ASI-IP-GTW User's Manual8.2 Etherne
Page 83 and 84:
ASI-IP-GTW User's Manual8.7 Physica
Page 85 and 86:
ASI-IP-GTW User's ManualLimits for
Page 87 and 88:
ASI-IP-GTW User's Manual10 Appendix
Page 89 and 90:
ASI-IP-GTW User's ManualFigure 39.
Page 91 and 92:
ASI-IP-GTW User's ManualFigure 41 S
Page 93:
ASI-IP-GTW User's Manual1.1.1.37 AS
show all

TVG420 User Manual 2.2 (SW release 1.2.2)

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?