Nevco Indoor LED Scoreboard Installation Manual

More documents

Recommendations

Info

Situation Symptom Connection SolutionThe messageCenter is notdisplaying amessageI cannotcommunicatewith themessagecenterPart ofmessagecenterappears“dead”The fans on ALL power supplies arerunningThe fans on ALL power supplies are notrunningOn a double sided Message Center, Oneside is displaying the message, the otheris not“ DSP” LED on controller IS blinking,but the CASCAN card has no LED’sblinking rapidly (like DSP on thecontroller).No Red Power LED lit on WirelessBridge POE.No Red Power LED lit on WirelessAccess Point POE.LAN LED on Controller not ON solidLAN LED on PC Ethernet port not ON,or PC says “ network unplugged”, “notconnected”.User’s manual on CD with wirelessequipment explains how to measure thewireless signal strengthOnly part of message center will lightC,DBK,cDEJDFHIGReplace crossover cableIn Composer, check the scheduling for the Project, thenclick the button to send the project to message centerCheck Power Switch on disconnect box inside messagecenterCheck connections in disconnect box (power hookup)Check branch circuit; was there a photocell on an existingsign install?Ensure an Ethernet straight through cable has been used, ismaking a good connection at both ends.Ensure an Ethernet crossover cable has been used, ismaking a good connection at both ends.Check branch circuit and power at the receptacle. Adapterhas LED indicatorCheck branch circuit and power at the receptacle. Adapterhas LED indicatorEnsure an Ethernet crossover cable has been used and ismaking a good connection at both endsEnsure an Ethernet straight through cable has been used andis making a good connection at both ends.Ensure an Ethernet straight through cable has been used andis making a good connection at both ends.Ensure an Ethernet crossover cable has been used and ismaking a good connection at both ends. Check to see thatthe network interface is enabled and follow the procedure in“Not connected to existing Network above.Reorient the wireless device’s antennas to eliminateobstructions between themIn Composer, check the zone section to make sure theproject is set to use the whole message centerTemperature Not installed A Install sensor in message centerSensor doesNOT work Not enabled Make sure the temperature sensor is enabled in ComposerLight Sensordoes NOTNot installed A Install sensor in message centerwork Not enabled Make sure the light sensor is set to auto in ComposerIf the problem persists please contact the Nevco Service Department.800-851-4040135-0144 Page 8
GLOSSARYACCESS POINT (WIRELESS AP)A hardware device that allows wirelesscommunication devices to connect to anetwork.Can also be configured as aWIRELESS BRIDGEA hardware device used to connect two ormore network segments.ACCESS POINTCASCAN cardDistributes the data inside the MessageCenter.CASCAN card135-0144 Page 9
Page 4: 3. Electrical ConnectionsPower Serv
Page 7 and 8: Wireless Troubleshooting GuideThe f
Page 9 and 10: Service RequestScoreboard Serial #
Page 12 and 13: Table of ContentsINSTALLATION INSTR
Page 14 and 15: Additional Suggested Mounting Metho
Page 16 and 17: Electrical ConnectionsRefer to inst
Page 18 and 19: Computer is Connected to an existin
Page 22 and 23: DISPLAY PanelA group of pixels. Sev
Page 24: Notes12

Nevco Indoor LED Scoreboard Installation Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?