PA50, 55 & 60 ECO MK2 - Operator Manual - McConnel

Remove leg pins and raise the stand legs totheir stowage position – replace leg pinsand secure in place with ‘R’ clips.Adjust check chains to prevent sidewaysmovement of the tractor’s linkage.Measure the PTO shaft and cut to thedimension shown below. The finished lengthof the shaft should be 75mm (3”) less thanthe measured distance ‘A’ between tractorshaft and gearbox stub shaft to allow forfitting. Refer to PTO installation page.NOTE: For subsequent use with differenttractors, measure again - there must be aminimum shaft overlap of 150mm (6”).When the PTO shaft is in position attachtorque chains to convenient locations toprevent rotation of the shaft guarding.Fit the machine control unit in the tractor cab in a convenient location that allows for safeand easy operation of all the controls and functions.15