ECO - 65 OWNER'S MANUAL - Drolet

3.9. REMOVAL AND REPLACEMENT OF BROKEN DOOR GLASSWARNING: ALWAYS WEAR SUITABLE GLOVES WHILE HANDLING BROKEN GLASS.Carefully remove any loose pieces of glass from the doorframe. Dispose of all broken glass properly.A broken glass must be replaced with an identical ROBAX (ceramic glass) 5 mm thick with the dimensions :10’’5/32 x 14’’21/32. Your authorized Drolet dealer can help you to obtain this genuine replacement part.To replace the glass, use the following procedure;1. Put the door assembly face down on a clean and non abrasive surface (towel, bubble wrap, etc.) toavoid damaging the door.2. Remove the screws and the 2 glass retainers.3. Remove the remaining broken glass.4. Remove the inner door frame adhesive gasket if necessary.5. To install the new glass, follow the above steps in reverse order.6. If the old gasket was removed, install a new inner door frame adhesive gasket #40018 as shown in thefollowing figures.In the handle area, apply the gasket in surrounding the cast iron extrusion to ensure an adequate airtightness.Cut the gasket using cutting pliers.