ASSEMBLY & OPERATION MANUAL - Inspire Fitness

NOTE: Once Assembled, slide rubberwasher against plastic ballSTEP 161 – Plastic Ball1 – Cable “U” Bracket1 – 1 ¼ “ Shoulder Bolt1 – Spring Clip1 – 5/16” Lock NutPulley 13NOTE: CABLE GOES INSIDE FRAME TUBESTEP 15Press Arm Mount2 – 3 ½” Pulleys Pulley 142 – 3” Hex Bolts4 – 3/8” Flat Washers2 – 3/8” Lock NutsStep 15:Begin by running upper cable from back of machine to frontas shown in the diagram. Next, slide pulleys 13 & 14 into thePress Arm Mount as cable is routed. Secure Press Arm Pulleys using:Two (3” Hex Bolts)Wrench Tighten Now.Four (3/8” Flat Washers)Two (3/8” Lock Nuts)Step 16: Assemble Cable End by sliding one plastic ball onto the end of the cable. Next slide thecable end into the side of the cable “U” bracket. Finally, attach spring clip to “U” bracket using a1 ¼” shoulder bolt and 5/16” lock nut. Wrench Tighten Now.Page 15