ASSEMBLY & OPERATION MANUAL - Inspire Fitness

More documents

Recommendations

Info

STEP 36Install Fabric ShroudTop Shroud PlateShroud Plate Adjustment BoltsBottom ShroudPlateStep 36: To install Fabric Shroud, start at the front of the top shroud plate and wrap the edgeof the fabric shroud around the shroud plate. Pull tight as you wrap and make sure thatthe velcro rim on the fabric shroud seals firmly to the velcro rim on the Shroud Plate.Next, Do the same for the bottom of the fabric shroud around the bottom shroud plate.Be sure to pull tight as fabric shroud is wrapped.If ripples appear on the fabric shroud, undo the top of the shroud and re-wrap, pullingup as the shroud is wrapped. This should give a nice smooth consistency to the shroud.(If necessary, shroud can be tightened by adjusting the Shroud Plate Adjustment Bolts.)Page 23
STEP 37STEP 38Note: When not in use, EZ curl bar orLat Bar can be stored in theaccessory holder.STEP 39Step 37: Attach Lat Bar to High Pulley with Spring ClipStep 38: Attach “D” Handles to Mid Pulley with Spring ClipStep 39: Attach Revolving EZ Curl Bar to Chain, then Chain to Low Pulley with Spring ClipsPage 24
Page 3: TABLE OF CONTENTSSection Descriptio
Page 6: HARDWARE CHART1" 2" 3" 4" 5" 6" 7"3
Page 9 and 10: ASSEMBLY INSTRUCTIONSPAGE 6
Page 11 and 12: Guide RodsSTEP 4Shroud PlateHoles m
Page 13 and 14: Note: Attach left and right top bea
Page 15 and 16: STEP 10Install Four PulleysPULLEY 1
Page 17 and 18: STEP 14Install Six Pulleys &One Cab
Page 19 and 20: STEP 19STEP 181 - Floating Pulley B
Page 22 and 23: Note: To assemble orthopedic pads,
Page 24 and 25: STEP 32Remove Bolts from Guide Rods
Page 28 and 29: STEP 41Press Arm StopCable BoltSTEP
Page 30 and 31: DECAL REFERENCEPAGE 27
Page 32 and 33: ACCESSORIES• Exercise Wall Chart
Page 34 and 35: MAINTENANCE SCHEDULEROUTINEInspect:

ASSEMBLY & OPERATION MANUAL - Inspire Fitness

Create successful ePaper yourself

Delete template?

Save as template?