Third Party Inspection Guidelines for Inspectors Technical ... - Dryvit
Third Party Inspection Guidelines for Inspectors Technical ... - Dryvit
Third Party Inspection Guidelines for Inspectors Technical ... - Dryvit
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Third</strong> <strong>Party</strong> <strong>Inspection</strong> <strong>Guidelines</strong> <strong>for</strong> CARE <strong>Inspectors</strong>SECTION THREE (Cont'd)dryvitCARE Site <strong>Inspection</strong> Checklist WorksheetThis section should be completed each time the CARE inspector visits the project site. Attach toSection Two at the completion of each visit.YES NO N/AD. Water-Resistive Applicable N/ABarrier/Air BarrierInstallation Cont'd6) Pre-spot fasteners and Grid Tapelocations7) Continuous layer of membrane appliedover entire surface areac. <strong>Dryvit</strong> Flashing Tape (sheathingapplications only)1) 100 mm, 150 mm or 230 mm (4 in,6 in, or 9 in) wide polyethylene filmbacked with a rubberized asphaltsupplied by <strong>Dryvit</strong> Systems, Inc.2) Rough openings prepared inweatherboard fashion3) Substrate expansion joints covered4) Air and surface temperature: °F or °C5) Surface is clean, dry and smooth6) <strong>Dryvit</strong> Flashing Tape SurfaceConditioner used7) Flashing tape extends 51 mm (2 in)over the water-resistive membrane.d. Notes:2. Sheet Type Water-Resistive Membranesa. Type of sheet material:b. <strong>Dryvit</strong> Flashing Tape installed asindicated in D.1.cc. Water-resistive barrier installedhorizontally in a weatherboard fashion
Change language