Carbon NIC-301 Model User Guide for SoC Designer

1-10 Using the Model Kit Component in SoC DesignerTable 1-4 Address Control RegistersName Description Typesecurity1securitySlave 1 security setting. 1 bit for non-virtualslaves, up to 16 for virtual or APB master interfaces,and you can configure it as follows:0 Secure1 Non-secureSlave n security setting. 1 bit for non-virtualslaves, up to 16 for APB master interfaces.read-writeread-write1.5.1.2 Peripheral ID RegistersIf you configure any registers in the programmers view, peripheral ID registers are alwaysvisible. This provides a low gate count option for identification. Table 1-5 shows theperipheral ID registers.Table 1-5 Peripheral ID RegistersName Description TypePeripheral_ID0 Peripheral Identification Register 0 - Part Number read-onlyPeripheral_ID1 Peripheral Identification Register 1 - JEP106 and Part read-onlyNumberPeripheral_ID2Peripheral_ID3Peripheral_ID4Peripheral Identification Register 2 - Revision,JEP106 code flag, JEP106Peripheral Identification Register 3 - Can be set usingthe AMBA Designer Graphical User Interface (GUI)Peripheral Identification Register 4 - 4KB count,JEP106 continuation coderead-onlyread-onlyread-onlyPeripheral_ID5 Peripheral Identification Register 5 - Reserved read-onlyPeripheral_ID6 Peripheral Identification Register 6 - Reserved read-onlyPeripheral_ID7 Peripheral Identification Register 7 - Reserved read-onlyComponent_ID0 Component Identification Register 0 - Preamble read-onlyComponent_ID1 Component Identification Register 1 - Generic IPcomponent class, preambleread-onlyComponent_ID2 Component Identification Register 2 - Preamble read-onlyComponent_ID3 Component Identification Register 3 - Preamble read-onlyCarbon Design Systems, Inc. Confidential