Intrusion Management Installation and User Guide - G4S Technology

Configuring the Intrusion Hardware4. Type "48" (ENG ACCESS) and press . "1=System Access" is displayed.5. Press . "1=Engineer" is displayed.6. Press . "0=Disabled" or "1=Enabled" is displayed.7. If "0=Disabled" is displayed, press "1" to display "1=Enabled" and press .8. Exit manager mode by pressing several times until the date and time are displayed.Step 2 – Enter Engineer ModeSelect the engineer mode "Settings" option as follows:1. Type "112233" and press .2. Warning or fault messages may be displayed. Press to continue.3. "10=SETTING" is displayed. Press .Step 3 – Set TCP Communications ProtocolSet TCP communications protocol, as follows:1. Type:"56" (COMMUNICATION) "4" (ETHERNET) "02" (ALARM REPORT) "8" (PROTOCOL) 2. Select "TCP" (using ), then press .3. Keep pressing until "56=COMMUNICATION" is displayed.Step 4 – Specify the IP Address and Port Number of the SMS ClientSet the IP address and port number of the SMS client PC as follows:1. Type:"56" (COMMUNICATION) "4" (ETHERNET) "02" (ALARM REPORT) "2" (PRIMARY IP) "1" (IP ADDRESS) . The current IP address is displayed.2. Press to delete the current IP address, type the IP address of the SMS client PC and press.3. Press until "2=PORT NO" is displayed, then press . The existing port number is displayed.8 Intrusion Management Installation and User Guide