DKG-705 AUTOMATIC MAINS FAILURE AND REMOTE START ...

DATAKOMDKG-705 User’s ManualProgram Group 6Group Parameter Definition6 600 Reset MaintenanceCounters6 601 Current TransformerPrimary6 602 Low Oil Pr.ShutdownUnit Min Max Description- 0 1 Setting this parameter to 1 will1) Reset the Time to Service variable toMaintenance Period (days) (P625) value,2) Reset the Engine Hours to Servicevariable to Maintenance Period (EngineHours) (P624) value.This means that a new service period hasstarted with default values.The program parameter P600 itself is notmodified and reads always 0.A 50 2500 This is the rated value of currenttransformers. All transformers must havethe same rating. The secondary of thetransformer will be 5 Amps.Bar 0 4.0 If the oil pressure measured from theanalog input falls below this limit while theengine is running, this will generate a LowOil Pressure Measured alarm and shutdown the engine immediately.6 603 Low Oil Pr. Warning Bar 0 4.0 If the oil pressure measured from theanalog input falls below this limit while theengine is running, this will generate a LowOil Pressure Measured Warning.6 604 High TemperatureShutdown?C 80 120 If the water temperature measured from theanalog input goes over this limit, this willgenerate a High Coolant TemperatureAlarm and shut down the engineimmediately.6 605 High Temp. Warning ?C 80 120 If the water temperature measured from theanalog input goes over this limit, this willgenerate a High Coolant TemperatureWarning.6 606 High Oil T. Shutdown ?C 80 250 If the oil temperature measured from theanalog input goes over this limit, this willgenerate a High Oil Temperature Alarmand shut down the engine immediately.6 607 High Oil T. Warning ?C 80 250 If the oil temperature measured from theanalog input goes over this limit, this willgenerate a High Oil TemperatureWarning.6 608 Low Fuel LevelShutdown6 609 Low Fuel LevelWarning% 0 50 If the fuel level measured from the analoginput falls below this limit, this will generatea Low Fuel Level Alarm and shut downthe engine immediately.%0 0 50 If the fuel level measured from the analoginput falls below this limit, this will generatea Low Fuel Level Warning.705-UE.doc - 39 -