13 MB 19th Jul 2013 5995373155 Frigidaire 27 Dryers Gas and ...

More documents

Recommendations

Info

National Standard for Mobile Homes. In Canada,the CSA Z240 is applicable.The dryer is designed under ANSI Z21.5.1 for HOME USE only.UNDER COUNTER & STACK MODELSROUGH-IN DIMENSIONS26 7/8”(68.3 cm)ELECTRICCONNECTION13 1/2"(34.4 cm)2 9/16”(6.5 cm)UNDERCOUNTER34 5/8"(87.9 cm)36"(91.5 cm)3 1/4”(9.5 cm)3/8" (0.96 cm) DIA.GAS PIPE 1” (2.54 cm)REAR VIEW47 1/2"(120.7 cm)DOOR OPEN 90°4 3/8"(11.1 cm)OPTIONALVENT KNOCKOUT3027”(68.6 cm)SIDE VIEW3 3/4"(9.5 cm)
TOP CONSOLE MODELSROUGH-IN DIMENSIONS(68.3 cm)ELECTRIC CONNECTIONUNPACKING1. Using the four shipping carton corner posts (twoon each side), carefully lay the dryer on its leftside and remove foam shipping base.To prevent damage, do not use thecontrol panel as a means to pick up or move thedryer.NOTE: On under counter model clothes dryers, thetop panel may be removed for installation.2. Return the dryer to an upright position.(6.5 cm)13 1/2"(34.4(110.7 cm)cm) 36"(91.5 cm)FOAMSHIPPINGPAD(9.5 cm)3/8" (0.96 cm) DIA.GAS PIPEREAR VIEW(2.54 cm)PACKINGREVERSING DOOR SWING47 1/2"(120.7cm)4 3/8"(11.1 cm)OPTIONALVENT KNOCKOUTYour dryer is designed so the door swing may bereversed at any time without additional parts.Conversion is accomplished by transferring hingesto the opposite side of the cabinet.To change the direction of the door opening:1. Open the dryer door. Remove the four hingehole plugs from the left side of the door opening.Place nearby for future installation. NOTE: Youmay need a plastic knife to help pull out theplugs. Be careful not to scratch the paint.2. Remove the four screws that secure the doorhinges to the dryer front panel. NOTE: Removeone screw from each of the two hinges first. Holdthe door firmly before removing the last twoscrews.3. Rotate the door 180° and reinstall the doorhinges to the dryer front panel with the fourscrews.4. Install the four hinge hole plugs in the open screwholes on the right side of the door opening.(68.6 cm)SIDE VIEW3 3/4"(9.5 cm)31
Page 2 and 3: SAFE SERVICING PRACTICES - ALL APPL
Page 4 and 5: Gas supply requirements 28Location
Page 6 and 7: Removing the top console skirt (Top
Page 8 and 9: QUICK REFERENCE SHEETSPECIFICATIONE
Page 11: SAMPLE WIRING DIAGRAM FOR ELECTRIC
Page 14 and 15: SECTION A - OPERATING INSTRUCTIONSC
Page 16 and 17: SECTION B - OWNERS GUIDEFor your sa
Page 18 and 19: location, have it checked and reins
Page 20 and 21: items, but do not let items hang ov
Page 22 and 23: Avoid ServiceChecklistOCCURRENCEDry
Page 24 and 25: FRIGIDAIRE DRYER WARRANTYYour Frigi
Page 26 and 27: PRE-INSTALLATION REQUIREMENTSTools
Page 28 and 29: EXHAUST DIRECTIONAll dryers shipped
Page 32 and 33: GROUNDING REQUIREMENTSNon-Canadian
Page 34 and 35: on the terminal block. Tighten the
Page 36 and 37: Control thermostatTimerOnce inside
Page 38 and 39: 1. Air being drawn in around the do
Page 40 and 41: Whenever the fabric selector switch
Page 42 and 43: Note:In the auto regular cycle, the
Page 44 and 45: change from NC to NO, opening the c
Page 46 and 47: Electrical Operation (Gas Dryers Mo
Page 48 and 49: The gas valve has two chambers in s
Page 50 and 51: SECTION F - TROUBLESHOOTING FLOW CH
Page 52 and 53: Gas dryer completely inoperative.No
Page 54 and 55: Electric dryers without electronic
Page 56 and 57: Electric and Gas dryers; blower mot
Page 58 and 59: Gas dryers; blower motor runs but d
Page 60 and 61: SECTION G - TEARDOWNThis section wi
Page 62 and 63: Removing the timer: (Front console
Page 64 and 65: Removing the press saver option swi
Page 66 and 67: Removing the end caps: (Top console
Page 68 and 69: Removing the door catch:1. Disconne
Page 70 and 71: 4. Release the five tabs, three at
Page 72 and 73: Releasing the dryer belt:1. Remove
Page 74 and 75: Note: Do not lose the grounding bal
Page 76 and 77: Removing the idler pulley:1. Discon
Page 78 and 79: Removing the sensor: (Gas dryers)1.

13 MB 19th Jul 2013 5995373155 Frigidaire 27 Dryers Gas and ...

Create successful ePaper yourself

Delete template?

Save as template?