Wireless Thermostat Installation Guide and the Control4

More documents

Recommendations

Info

Figure 6. Bypass Resistor23Access the 24V transformer and integrated control panel on the HVAC system. This typicallyrequires removing the front panel of the furnace. Remember to turn OFF the power to theHVAC system before accessing the transformer.Install the resistor on the HVAC system, not on the Thermostat. Wire the resistor from theHeat Relay Terminal (W or W1) to the common side of the 24Volt HVAC system transformer.Figure 7 shows the wiring diagram of a typical single-stage HVAC system with the resistor inplace.24
Figure 7. Gas/Electric Single Stage25
Page 1 and 2: WirelessThermostatInstallationGuide
Page 3: Table of ContentsSupported Model ..
Page 7 and 8: SpecificationsFront and Rear ViewFi
Page 9 and 10: • New construction, Control4 reco
Page 11 and 12: Installation Instructions1234Place
Page 13 and 14: 1415Select the desired power supply
Page 15 and 16: Composer Programming InstructionsAl
Page 17 and 18: Time FormatDate Format: Sets the fo
Page 19 and 20: NOTE: For multistage systems, the d
Page 21 and 22: Primary Fan (Electric), Secondary F
Page 23 and 24: Primary Fan (Electric), Secondary F
Page 25 and 26: Heat Pump: CoolingPrimary Fan (Fuel
Page 27: Installing a Bypass Resistor to Ena
Page 31 and 32: Example 2. This second example (Fig
Page 33 and 34: Wiring ConnectionsTo see which rela
Page 35 and 36: Figure 11. Conventional, Dual Stage
Page 37 and 38: Figure 13. Heat Pump with Electric
Page 39 and 40: Figure 15. Heat Pump with Electric

Wireless Thermostat Installation Guide and the Control4

Create successful ePaper yourself

Delete template?

Save as template?