2. installation procedure for optional equipment - toshiba tec europe

More documents

Recommendations

Info

1. UNPACKING EO18-120101.3 Tapes1.3 TapesRemove all the tapes from the POS terminal.1.4 Notes for InstallationWARNING!1. Care must be taken not to get your fingers caught between the LCD Frame and the POS terminalwhen bending the display backward.2. DO NOT raise the LCD Frame while the Front Cover is not in position. When the LCD Frame israised at right angle (90°) or more, the LCD may fall under its own weight, and your fingers may becaught.CAUTION!1. When removing the protective film from the display surface, please be sure to do it slowly. If it isdone quickly, static electricity may generate, and the TFT may be damaged.2. When installing the POS terminal, take the following precautions. Failure to do this may cause fire,electric shock, or injury.(1) Avoid locations where it is subject to the following:• Direct sunlight• High temperature, high humidity• Rapid change in temperature• Excessive vibration• Dust(2) Keep away from any devices that emit magnetism or electromagnetic wave.(3) Keep away from flame or moisture.(4) Be sure to place the POS terminal on a level and stable surface.1. Place the POS terminal on a level surface.2. Provide a minimum space to the left, right, front and rear of the POS terminal for proper cooling.(The unit has air vents and a fan on the front and left. Spaces should be provided to prevent the air ventsfrom being blocked and the air flow from being obstructed.)80 mm(See NOTE.)80 mm80 mmSee NOTE.80 mmNOTE: A fan is provided on these sides. Do not prevent the ventilation of the fan.1- 2
2. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-120102.1 Installing the Hard Disk Drive (HDD)2. INSTALLATION PROCEDURE FOR OPTIONALEQUIPMENTWARNING!1. Disconnect the power cord before installing the optional parts.2. Be careful not to short-circuit the lithium battery on the ENGINE PC board.NOTES:1. When assembling, be careful not to let the Front Cover catch any cables. Lead the cables through the U-shaped holes on the Front Cover so that the Front Cover is closed correctly.Front Cover2. When the cable is connected to the USB port, lead the cable obliquely downward then secure with the fastenband as shown below. If lead directly below, the cable may come off.Fasten BandUSB CableThis section describes procedures to install optional equipments into the POS terminal.2- 1
Page 1 and 2: TEC POS TerminalST-71 SERIESMainten
Page 3 and 4: EO18-12010(Revision Date: Jan. 30,
Page 5: 1. UNPACKING EO18-120101.1 Procedur
Page 9 and 10: 2. INSTALLATION PROCEDURE FOR OPTIO

2. installation procedure for optional equipment - toshiba tec europe

Create successful ePaper yourself

Delete template?

Save as template?