Visualiner Series - Snap-on Equipment

3d-ii. Advanced Driver Complaint -- when placedin the "Automatic" mode, the <strong>Visualiner</strong> softwareexamines the caster, camber, SAI, and toe readingsand specifications during thealignment routine and displaysan analysis of typical driversymptoms or vehicle problems.This does add additional stepsto the alignment process. Thissame analysis can be obtainedfor any vehicle as desired by theoperator when the choice of "Byrequest only" is selected. Seepage 60 for more details.3d-iii. Setback/Vehicle Dimensions -- this setupdetermines whether the setback measurement ismade automatically by the <strong>Visualiner</strong> software as apart of the standard alignmentroutine. On 8-sensor SurroundSensor models, vehicle dimensioning(i.e. wheelbase &trackwidth) is a part of the setbackroutine. Even if these measurementsare not setup withinthe path they can be selectedduring the alignment of any vehicle.3d-iv. Calibration check -- this selection is onlypossible with 8-sensor Surround Sensor models.These units have the ability to perform automaticcalibration checks with each alignment performedand alert the operator to an outof-calibration condition. Underthe Calibration Check Menu isthe "Threshold setting" whichselects the point where a warningmessage is displayed whenthe unit moves out of calibration.The "Force recalibration .." optionrequires a password to enable.For more details see theSurround Sensor OperationSupplement included with the 8-sensor heads.Page 34