DTXPLORER Owner's Manual - Yamaha

● AUX IN Jack (Stereo Mini Phone Jack)
You can connect the audio outputs from a CD player, or other external
audio source, to the AUX IN jack to mix the signal from the
external source with the signal from the DTXPLORER. The combined
audio can be sent on to an external device via the
DTXPLORER’s output jacks. This jack can be used when you want
to play along with a favorite tune or perform with friends.
Use the volume control on the external device (CD player,
etc.) to adjust the volume balance.
● MIDI OUT Jack
The DTXPLORER’s MIDI function lets you play voices on an
external tone generator with the DTXPLORER’s pads, or synchronize
the DTXPLORER’s song or metronome playback with the
playback of an external sequencer.
About MIDI
MIDI (Musical Instrument Digital Interface) is a world standard that
provides a means to connect instruments and computers and allow
them to transmit and receive performance and other data. This standard
allows computers and instruments of different makers and types
to communicate.
Always use a standard MIDI cable when connecting devices.
Also, use a MIDI cable that is not more than 15m in
length. Using a longer cable may result in irregular operation
and other problems.
■ Connecting the Power Supply
Connections
A special power source adaptor supplies power
to the DTXPLORER.
Make sure the power is switched OFF and connect the power adaptor
to the DC IN jack on the rear panel.
To prevent the cord from becoming unplugged, wrap the cord
around the cord hook and secure.
WARNING
Make sure that the power adaptor’s cord is not bent
at an acute angle when wrapping the cord onto the
hook. Such a situation can result in a damaged power
cord or fire.
CAUTION
Use ONLY a Yamaha PA-3C AC Power Adaptor (or
other adaptor specifically recommended by Yamaha).
The use of other adaptors may result in irreparable
damage to both the adaptor and the instrument.
Also, when the DTXPLORER is not to be used for a
long period of time, please unplug the power adaptor.
Before switching the power ON.
• To protect the speakers, headphones and the
DTXPLORER from damage, fully rotate the POWER/
VOL knob to the left (minimum volume) before
switching the power ON.
• Make sure the power is switched OFF on all external
devices connected to the DTXPLORER. After
the DTXPLORER’s power is switched ON, switch
the other device’s power ON.
11