12.07.2015 Views

November 2004 (PDF 11.6 MB) - Barrick Gold Corporation

November 2004 (PDF 11.6 MB) - Barrick Gold Corporation

November 2004 (PDF 11.6 MB) - Barrick Gold Corporation

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Cowal <strong>Gold</strong> Project – Noise Management PlanTable 7L Amax Noise Levels across Lake Cowal - ConstructionProject PhaseDistance From Lake Edge Closest to Construction ActivityL Amax Noise Level (1.5 m/s wind) - dBA1.5 km 2 km 4 km 5.5 km 6 km 7 km 10 kmConstruction (Year -1) 53 44 35 29 30 26 25After: Richard Heggie Associates, 1997Birds tend to habituate to constant steady noise levels, even of a relatively high level in the order of70 dBA (Richard Heggie Associates, 1997). Table 7 indicates that the maximum noise levels underadverse weather conditions at the closest monitored area at Lake Cowal would be 53 dBA duringconstruction (Richard Heggie Associates, 1997). This is below the level of 70 dBA, above which somedegree of environmental changes in birds have been observed (Richard Heggie Associates, 1997).Monitoring of potential noise impacts on bird breeding is discussed in Section 8.5.1.2 Monitoring Construction NoiseNoise levels during peak construction periods will be monitored at the following locations, as agreedwith NPWS (NPWS, pers. comm., 21 May 2003):• NO1 - New Lake foreshore;• NO2 - ‘Coniston’ residence;• NO3 - bird breeding area;• NO4 - bird breeding area;• NO5 - ‘Gumbelah’ residence; and• NO6 - ‘Lake Cowal’ residence.Section B1.2 of Appendix B of the INP (Appendix A) describes procedures for unattended long-termmonitoring of noise. Procedures that could be adopted are as follows:1. Field-calibrate the noise monitoring equipment.2. Monitor the background noise and meteorological conditions continuously for each day of theweek that the development will be operating and over the proposed operating hours, using theL A90(15 minute) descriptor.3. Note the dominant and background noise sources present at the site throughout the monitoringperiod.4. Check the field calibration at the conclusion of the monitoring period in accordance withAS 1259.1 (now superseded by AS IEC 61672.1-<strong>2004</strong> [Appendix D] and AS IEC 61672.2-<strong>2004</strong>,[Appendix E]) and AS 2659.1 (Appendix F) to ensure that any calibration drift is allowed byrelevant Australian Standards.5.2 IMPACTS DURING OPERATION PHASE5.2.1 Hours of OperationThe hours of mining and processing operations will be 24 hours per day, Monday to Sunday (RichardHeggie Associates, 1997).HAL-02-07/1/NMP01-P/17/11/04 13 BARRICK

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!