Waters 2414 Refractive Index Detector

Connecting to the electrical power supplyTo connect the 2414 refractive index detector to the AC power supply1. Plug the receptacle end of the power cord into the AC power inputreceptacle on the rear panel of the detector (see the figure on page 2-4).2. Plug the other end of the power cord into a grounded AC power source.For information about the remaining rear panel electrical connections, seeChapter 3, “Connecting Signal Cables”.Connecting tubing and attachmentsWarning: To avoid chemical hazards, always observe GoodLaboratory Practices when handling solvents. Refer to theMaterial Safety Data Sheets for solvents in use.Warning: To avoid hazards associated with spilledchemicals, ensure waste containers are large enough toaccommodate analysis requirements.This section describes procedures for connecting the detector to thesecomponents:• A column or another detector• A waste container• The drip trayThe tubing connections for the detector are on the front panel, behind thefront cover and to the left of the keypad.Connecting to the electrical power supply 2-5