ODGR400, ODGR500 - Unvented Gas Log Heater or Vented ...
ODGR400, ODGR500 - Unvented Gas Log Heater or Vented ...
ODGR400, ODGR500 - Unvented Gas Log Heater or Vented ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ODGR Series Outdo<strong>or</strong> <strong>Gas</strong> FireplaceRemote Wall SwitchNOTE: Use an approved outdo<strong>or</strong> switch.1. Thread wire through the low voltage wire access holelocated on either side of unit. Do not cut wire <strong>or</strong> insulationon metal edges. Ensure that wire is protected.Run the other end to a conveniently located wallreceptacle box.2. Attach wire to switch and install switch into receptaclebox. Attach cover plate to switch.3. Connect wiring to gas valve. Refer to Figure 11.CAUTION: Do not wire millivolt remotewall switch f<strong>or</strong> gas appliance to a 120vpower supply.F<strong>or</strong> lighting instructions, refer to Page 12.NOTE: If glass do<strong>or</strong>s are installed, the unit must beoperated with the do<strong>or</strong>s fully open. (Fig. 12) If thedo<strong>or</strong>s are not fully open, the thermodisk will automaticallyturn the unit off.CAUTION: After the unit cools, the burnerwill automatically come on.On/OffSwitchPilotFig. 11 Remote switch wiring.ThermodiskTPTH TP THValveHV105OPENC<strong>or</strong>rect Wrong MD706-7Fig. 12 C<strong>or</strong>rect do<strong>or</strong> position during operation.HV105Generic <strong>Gas</strong> Valve9/22/99 djtMD706-7Glass Do<strong>or</strong> Position1/20/9992D0001
Change language