Service Manual Number 11 Removal Installation And Adjustments
Service Manual Number 11 Removal Installation And Adjustments
Service Manual Number 11 Removal Installation And Adjustments
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
REMOVAL, INSTALLATION AND ADJUSTMENTS SERVICE MANUAL NUMBER <strong>11</strong>2. Disconnect the trim sender wires.3. Disconnect MerCathode wires from controller (if so equipped).From Engine HarnessaFrom Gimbal Housing24841Models With Bullet Connectors on Trim Sender Wiresa - Bullet Connectorsga b c d e f22032Models With Trim Sender Wire Connections At The MerCathode Controllera - ORANGE Lead - From Electrode on Transom Assemblyb - RED/PURPLE Lead - Connected (Other End) to Positive (+) Battery Terminalc - BLACK Lead - From Engine Harnessd - Trim Position Sender Leade - BROWN Lead - From Electrode on Transom Assemblyf - Trim Position Sender Leadg - BROWN/WHITE Lead - From Engine Harness4. Disconnect gear lube monitor warning horn wires, if so equipped.5. Remove engine (refer to appropriate engine service manual).6. Disconnect trim limit switch wires.7. Remove power trim pump hydraulic hoses and disconnect trim limit switch wires. Caphoses and plug pump fitting holes.cba - Sta-strapb - Trim Limit Switch Wiresc - Hydraulic Hosesa22031Page 2A-10 90-17431--4 MARCH 1998