Service Manual Number 11 Removal Installation And Adjustments

REMOVAL, INSTALLATION AND ADJUSTMENTS SERVICE MANUAL NUMBER 11c. With the fitting fully seated, turn the handle clockwise to a tightly seated position.aa - Fitting Installed (Handle Pointing Forward)Shift Cable Installation and Adjustment22025NOTE: Using Adjustment Tool (91-12427), shift cables can be adjusted without or with thesterndrive installed, using the following procedure.IMPORTANT: Front propeller on Bravo Three drive unit is always LH rotation and rearpropeller is always RH rotation. Shift cable end guide must move in direction A, whencontrol lever is placed in Forward gear position.ABRAVO THREEIMPORTANT: For Bravo One and Two: Drive unit propeller rotation is determined bythe shift cable installation in the remote control.• If shift cable end guide moves in direction “A,” when control lever is placed inForward, remote control is setup for RIGHT HAND (RH) propeller rotation.• If shift cable end guide moves in direction “B,” when control lever is placed inForward, remote control is setup for LEFT HAND (LH) propeller rotation.71656ABBRAVO ONE AND TWO22024IMPORTANT: When installing shift cables, be sure that cables are routed in such away as to avoid sharp bends and/or contact with moving parts. DO NOT fasten anyitems to shift cables.Page 2A-34 90-17431--4 MARCH 1998