Service Manual Number 11 Removal Installation And Adjustments

More documents

Recommendations

Info

REMOVAL, INSTALLATION AND ADJUSTMENTS SERVICE MANUAL NUMBER 11Sterndrive Unit Removal1. Shift remote control into neutral.2. Trim the drive unit to the full “up” position.CAUTIONAvoid speedometer hose fitting damage. Disconnect the speedometer hose fittingfrom the drive shaft housing before removing the sterndrive unit.3. Disconnect the speedometer hose fitting from the drive shaft housing.220254. Trim the drive unit to the full “down” position and remove the power trim cylinder fromthe aft end of the drive shaft housing.cdba22029a - End Capb - Nutc - Small I.D. Washerd - Rubber BushingPage 2A-6 90-17431--4 MARCH 1998
SERVICE MANUAL NUMBER 11REMOVAL, INSTALLATION AND ADJUSTMENTS5. Remove the locknuts holding the sterndrive onto the bell housing, then remove thesterndrive unit. Make sure the shift cable linkage jaws open and release the shift cableend.ba22031a - Locknuts and Washersb - Ground Plate (Continuity Washer Not Used Here)dc22025c - Shift Linkage Jaws (Open)d - Shift Cable End (Released from Jaws)90-17431--4 MARCH 1998 Page 2A-7
Page 1 and 2: SERVICE MANUAL NUMBER 11REMOVAL, IN
Page 3 and 4: SERVICE MANUAL NUMBER 11Transom Spe
Page 5: SERVICE MANUAL NUMBER 11REMOVAL, IN
Page 13 and 14: SERVICE MANUAL NUMBER 1112. On Dies
Page 15 and 16: SERVICE MANUAL NUMBER 11Transom Ass
Page 19 and 20: SERVICE MANUAL NUMBER 118. Connect
Page 25 and 26: SERVICE MANUAL NUMBER 11aREMOVAL, I
Page 27 and 28: SERVICE MANUAL NUMBER 11Sterndrive

Service Manual Number 11 Removal Installation And Adjustments

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?