Service Manual Number 11 Removal Installation And Adjustments

More documents

Recommendations

Info

REMOVAL, INSTALLATION AND ADJUSTMENTS SERVICE MANUAL NUMBER <strong>11</strong>IMPORTANT: The edge of the U-joint bellows acts as a seal between the bell housingand the drive shaft housing. Ensure that the surface is not damaged.aa - Drive Shaft Bellows Edge247255. Inspect the drive shaft bellows for cracks, nicks, and cleanliness. Replace or clean thebellows as necessary.6. Lubricate the O-ring seals on the face of the drive shaft housing.aa - O-Ring Seals22031Page 2A-28 90-17431--4 MARCH 1998
SERVICE MANUAL NUMBER <strong>11</strong>REMOVAL, INSTALLATION AND ADJUSTMENTS7. Pull out the shift linkage as far as it moves. The jaws will open. Lubricate the undersideof the lower lip of the shift linkage assembly with Special Lubricant 101.bacca - Shift Linkage Assemblyb - Jaws - Openc - Underside of Lower Lip22025IMPORTANT: As you are inserting the sterndrive unit into the bell housing, the entranceof the bell housing shift cable must be closely checked to ensure that the cableenters the “Jaws” of the shift linkage assembly in the drive unit.NOTE: As the shift cable enters the shift linkage assembly, it pushes the assembly back intothe drive shaft housing, and the jaw closes, securing the cable as shown in A, B, and C (below).2202590-17431--4 MARCH 1998 Page 2A-29
Page 1 and 2: SERVICE MANUAL NUMBER 11REMOVAL, IN
Page 3 and 4: SERVICE MANUAL NUMBER 11Transom Spe
Page 13 and 14: SERVICE MANUAL NUMBER 1112. On Dies
Page 15 and 16: SERVICE MANUAL NUMBER 11Transom Ass
Page 19 and 20: SERVICE MANUAL NUMBER 118. Connect
Page 25 and 26: SERVICE MANUAL NUMBER 11aREMOVAL, I
Page 27: SERVICE MANUAL NUMBER 11Sterndrive

Service Manual Number 11 Removal Installation And Adjustments

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?