Shire Owners' Manual (11 Build) 70 & 90 (PDF) - EP Barrus

More documents

Recommendations

Info

11. Electrical Options• If the engine is fitted with the optional VDO travel power system, refer to the manualsupplied with it for correct wiring, control box installation and operation.• The Shire range can be supplied with an optional additional 12v or 24v alternator.This will be supplied fitted but not wired. It is the responsibility of the boat builder toensure that this is correctly wired to the boats electrical system.12. Engine Oil• All Shire engines are supplied fully run in.• Check oil levels in engine and gearbox before starting. (The gearbox uses the samegrade of oil as the engine).• Shire 70, use good quality engine oil SAE 15w / 40 API class CD.• Shire 90, use John Deere engine oil, see page 34.WARNING:ENGINE OIL WITH A HIGHER API CLASS THAN SPECIFIED IS UNSUITABLE FORCANAL BOAT ENGINE OPERATION AND WILL CAUSE ENGINE DAMAGE IF USED.13. Fuel• Ensure the main fuel tank is clear of dirt & water.• A separate water trap is strongly advised. (The engine is supplied with a small watertrap as standard).• Connect fuel feed and return hoses from engine to main fuel tank via supply andreturn lines. Ensure that they are connected the correct way around.• Shire 70 – connect the inlet to the electric fuel pump inlet hose.• Shire 90 – connect to the inlet to the primary fuel filter inlet hose.• The fuel supply and return hoses are fitted with 10mm (3/8”) hose tails.• The engine hoses should have sufficient slack to absorb engine movement withoutplacing strain on the hoses, and be securely clipped to prevent accidental damageand chafing.• Initially fill the fuel system loosening the bleed bolt on the top of the primary fuelfilter/water trap. For Shire 70, turn on the ignition to operate the electric fuel pump.For Shire 90, pump the primer on the primary filter. Close when fuel begins to flowclearly (no bubbles). It is rarely necessary to bleed the injection pump or injectorsupon installation as the engine will already have fuel in it from the engine run-in andRDG6039258 Issue 5 Shire 70 & 90 Owners Manual Page 18 of 48
test procedure.14. Coolant• Yanmar recommend a prepared coolant mix of 60% clean tap water and 40%antifreeze, John Deere recommend that Coolguard be used (see P 34).• Open the calorifier taps (where fitted) to fill the calorifier system and displace air.• To fill the cooling system for the first time. Fill the skin tank via the inlet hoseconnection or filler plug if fitted.• Fill engine through the white plastic expansion bottle.• N.B. After running the engine for the first time, monitor the water level frequently astrapped air bubbles may be expelled. Top up the system as necessary.15. Calorifier• The temperature of coolant flowing to the calorifier from the engine can be between85°C-90°C. A blender valve must be incorporated in the calorifier/hot water systemoutlet to lower the hot water temperature for domestic use.CalorifieroutletCalorifierinletFigure 3-7: Shire 70 Calorifier ConnectionsRDG6039258 Issue 5 Shire 70 & 90 Owners Manual Page 19 of 48
Page 1 and 2: SHIRE CANAL BOAT MANUALFOR THE FOLL
Page 3 and 4: Declaration of Conformity for Recre
Page 5 and 6: CONDITIONS THAT MUST BE MET IN ORDE
Page 7 and 8: SECTION 8 - WIRING DIAGRAMS........
Page 9 and 10: • If charging the battery; ensure
Page 11 and 12: SECTION 3 - Installation1. Ventilat
Page 13 and 14: Figure 3-2: Shire 70 Header Tank Co
Page 15 and 16: Figure 3-5: Correct Anti-Vibration
Page 17: 10. ElectricsWARNING:The blue link
Page 21 and 22: • The maximum domestic battery ba
Page 23 and 24: 3. Stopping Procedure• Move speed
Page 25 and 26: SECTION 5 - Service Procedure1. Eng
Page 27 and 28: PRM 260 gearbox filler circled in t
Page 29 and 30: 9. Fuel System Bleeding• Ensure t
Page 31 and 32: • Remove the belt.• Hold the be
Page 33 and 34: SECTION 6 - Service PartsShire 70Sp
Page 35 and 36: SECTION 8 - Wiring Diagrams1. Engin
Page 37 and 38: 3. Engine Wiring Diagram, Shire 90
Page 39 and 40: 5. Deluxe Panel Wiring Diagram (24
Page 41 and 42: 6. VDO 7KW Wiring diagram and overa
Page 43 and 44: SECTION 9 - General Arrangement Dra
Page 45 and 46: 3. Shire 11 909685022117 x 6.DETAIL
Page 47 and 48: SECTION 10 - Dealer ListArea Compan

Shire Owners' Manual (11 Build) 70 & 90 (PDF) - EP Barrus

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?