Shire Owners' Manual (11 Build) 70 & 90 (PDF) - EP Barrus

2. Air Filter Check & ChangeCAUTION:WEAR DISPOSABLE GLOVES AND BEWARE OF HOT OIL AND ENGINE BLOCK.REMOVE THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.• Release the two spring clips, pull off the end cover to reveal the filter element. Theelement simply pulls out. Note: the Shire 90 has an inner safety element fitted.• The air filter element is constructed from pleated paper; inspect it closely for dust ordirt. The air filter cannot be cleaned and must be replaced when dirty. The enginerequires clean unrestricted air to run efficiently, failure to maintain the air filter couldresult in smoke, increased fuel consumption and ultimately engine damage.• To fit the new element, slide the open end of the filter element into the main body;gently push the element home until fully seated. Refit the end cover.3. Gearbox Oil ChangeCAUTION:WEAR DISPOSABLE GLOVES AND BEWARE OF HOT OIL AND GEARBOX CASING.REMOVE THE IGNITION KEY, BEFORE WORKING IN ENGINE COMPARTMENT.• Change the gearbox oil while it is still hot. (Please refer to gearbox manual for moreinformation).• Remove the plug from the gearbox drain pump; this is the smaller of the two pumps(6mm Allen key).• Pump contents in a suitable container (not less than 2.2 litres).• Refill the gearbox with oil to the upper mark on the dipstick. Screw dipstick in fully toestablish level. The gearbox uses the same grade of oil as the engine.• Do not overfill gearbox as this can damage the internal components.RDG6039258 Issue 5 Shire 70 & 90 Owners Manual Page 26 of 48