Lutron EcoSystem Programming - Lutron Lighting Installation ...

More documents

Recommendations

Info

14 <strong>EcoSystem</strong>TM ProgrammerConfiguring Fixture GroupsA group of fixtures must be configured for each sensor or control.By grouping multiple fixtures, lighting zones can be easily set up andchanged. Any of the grouping modes can be configured from any IRreceiver. It is not necessary to directly access the sensor beinggrouped.1 From the Main Menu, tapGrouping.2 Tap the icon for the sensor orcontrol to be configured.3 Read the instructions, thentap to continue.4 Point the programmer at anyIR control device and tapto begin communication.5 If a fixture connected to thesensor flashes and otherfixtures go to minimumbrightness, tap .NOTE: If all fixtures flash threetimes and then return to normal,no sensor was detected.6 Use the left and right arrowbuttons to scroll to the sensoryou want to group (itsconnected fixture will flash).Tap to configure theselected sensor.7 If the fixtures for this sensorgo to full brightness and otherfixtures go to minimumbrightness, tap .26
<strong>Programming</strong> Guide 158 Scroll to the desired fixture(selected fixture will flash). Tap+ to add the fixture to thegroup, or – to remove it.Repeat this step for eachfixture to be added orremoved from the group.9Select Done Grouping to exit.Or select Group AnotherReceiver to configure anothergroup.10 When done, if all fixtures go tohigh level, tap .Repeat this procedure toconfigure groups for each sensorand control.89
Page 1: EcoSystemTM Programmer | Programmin
Page 4 and 5: 2 EcoSystemTM ProgrammerSetting a B
Page 6 and 7: 4 EcoSystemTM ProgrammerTransmittin
Page 8 and 9: 6 EcoSystemTM ProgrammerLogging InW
Page 10 and 11: 8 EcoSystemTM ProgrammerInformation
Page 12 and 13: ProgrammingYour System3Typical Prog
Page 14: 12 EcoSystemTM ProgrammerAddressing
Page 19 and 20: Programming Guide 177 Select the da
Page 21 and 22: Programming Guide 1910 Tap the desi
Page 23 and 24: Programming Guide 2110 Depending on
Page 25 and 26: Programming Guide 237 For occupant
Page 27 and 28: Programming Guide 259 Select Done.1
Page 29 and 30: Setting a Ballast’s High End Trim
Page 31 and 32: Setting a Ballast’s Emergency Lev
Page 33 and 34: Manually Adjusting the Light LevelP
Page 35 and 36: Programming Guide 33Replacing Balla
Page 37 and 38: Resetting a Ballast to Factory Defa
Page 39 and 40: IndexAaddressing the systemaddressi
Page 41 and 42: Programming Guide 39programmercharg
Page 44: www.lutron.comLutron Electronics Co

Lutron EcoSystem Programming - Lutron Lighting Installation ...

Create successful ePaper yourself

Delete template?

Save as template?