Lutron EcoSystem Programming - Lutron Lighting Installation ...

More documents

Recommendations

Info

22 <strong>EcoSystem</strong>TM ProgrammerSetting an Additional Timeout Period for OccupantSensors and Contact Closure DevicesOccupant sensors and contact closure devices can be set up toturn fixtures off automatically after a period of inactivity. The defaulttimeout is zero seconds. Any timeout programmed into the ballastwill be in addition to that of the occupant sensor. Consult theinstallation guide for your occupant sensor to determine the totaldelay.1 From the Main Menu, tapDevice Setup and thenOccupant Sensor or ContactClosures.2 Read the instructions, thentap to continue.3 Point the programmer at anyIR control device and tapto begin communication.4 For contact closure devices,select contact closure 1 or 2.5 For occupant sensors, scrollto the sensor to be set (itsgroup of fixtures will flash).Then tap to configure theselected sensor.For contact closures, if afixture group goes to fullbrightness and other fixturesgo to minimum brightness,tap .6 If all fixtures go to minimumbrightness and a fixtureconnected to an occupantsensor flashes, tap .68
<strong>Programming</strong> Guide 237 For occupant sensors, iffixtures in the selected sensorgroup go to occupied leveland other fixtures go tominimum brightness, tap .8 Select Set Timeout.9 Note the warning, then tapto continue.10 Select the number of minutesof inactivity after which thefixture group will turn off.11 Select Done.12 Depending on what you wantto do next, select:• Continue Setup of CurrentSensor• Setup Another Sensor• Done13 When done, if all fixtures flashand then go to high level, tap.Repeat this procedure to set atimeout for each occupant sensorand contact closure device.1011
Page 1: EcoSystemTM Programmer | Programmin
Page 4 and 5: 2 EcoSystemTM ProgrammerSetting a B
Page 6 and 7: 4 EcoSystemTM ProgrammerTransmittin
Page 8 and 9: 6 EcoSystemTM ProgrammerLogging InW
Page 10 and 11: 8 EcoSystemTM ProgrammerInformation
Page 12 and 13: ProgrammingYour System3Typical Prog
Page 14: 12 EcoSystemTM ProgrammerAddressing
Page 17 and 18: Programming Guide 158 Scroll to the
Page 19 and 20: Programming Guide 177 Select the da
Page 21 and 22: Programming Guide 1910 Tap the desi
Page 23: Programming Guide 2110 Depending on
Page 27 and 28: Programming Guide 259 Select Done.1
Page 29 and 30: Setting a Ballast’s High End Trim
Page 31 and 32: Setting a Ballast’s Emergency Lev
Page 33 and 34: Manually Adjusting the Light LevelP
Page 35 and 36: Programming Guide 33Replacing Balla
Page 37 and 38: Resetting a Ballast to Factory Defa
Page 39 and 40: IndexAaddressing the systemaddressi
Page 41 and 42: Programming Guide 39programmercharg
Page 44: www.lutron.comLutron Electronics Co

Lutron EcoSystem Programming - Lutron Lighting Installation ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?