Lutron EcoSystem Programming - Lutron Lighting Installation ...

More documents

Recommendations

Info

30 EcoSystemTM ProgrammerSeasoning New Fluorescent LampsNew fluorescent lamps can have impurities in them that lampmanufacturers cannot eliminate completely. Lutron recommends thatlamps be operated at full intensity for 100 hours before dimming to“season” or neutralize the harmful effects of these impurities.When a system is first installed, program ballasts to season all newlamps. As lamps are added or replaced, program the seasoningprocess only for those specific ballasts.1 From the Configure Menu, tapLamp Seasoning.NOTE: For procedures on how toto select one or all ballasts andthen display the Configure menu,refer to page 26.2 Select Start Lamp Seasoning.Otherwise, select CancelLamp Seasoning.NOTE: To temporarily pause theseasoning process (e.g., to makeprogramming adjustments), selectPause Lamp Seasoning.3 If selected ballast(s) flash andgo to their high level, tap .4 Depending on what you wantto do next, select:• Continue Configuration ofCurrent Ballast(s)• Configure DifferentBallast(s)• Done5 When done, if the lastconfigured ballast(s) flash,tap .12
Manually Adjusting the Light LevelProgramming Guide 31The light level can be manually adjusted for all fixtures in an IRreceiver group. The adjusted light level remains in effect until one ofthe following occurs:• An emergency situation occurs• A daylight sensor lowers the fixture to compensate for naturallighting• The room becomes unoccupied, or• A user manually adjusts the level again1 From the Main Menu, tapLighting Control.2 Read the instructions, thentap to continue.3 Point the programmer at theIR receiver whose groupfixture(s) are to be adjusted,then tap a light level.4 If needed, use the arrow keysto adjust the selected levelincrementally up or down.5 Tap Main Menu to exit.134
Page 1: EcoSystemTM Programmer | Programmin
Page 4 and 5: 2 EcoSystemTM ProgrammerSetting a B
Page 6 and 7: 4 EcoSystemTM ProgrammerTransmittin
Page 8 and 9: 6 EcoSystemTM ProgrammerLogging InW
Page 10 and 11: 8 EcoSystemTM ProgrammerInformation
Page 12 and 13: ProgrammingYour System3Typical Prog
Page 14: 12 EcoSystemTM ProgrammerAddressing
Page 17 and 18: Programming Guide 158 Scroll to the
Page 19 and 20: Programming Guide 177 Select the da
Page 21 and 22: Programming Guide 1910 Tap the desi
Page 23 and 24: Programming Guide 2110 Depending on
Page 25 and 26: Programming Guide 237 For occupant
Page 27 and 28: Programming Guide 259 Select Done.1
Page 29 and 30: Setting a Ballast’s High End Trim
Page 31: Setting a Ballast’s Emergency Lev
Page 35 and 36: Programming Guide 33Replacing Balla
Page 37 and 38: Resetting a Ballast to Factory Defa
Page 39 and 40: IndexAaddressing the systemaddressi
Page 41 and 42: Programming Guide 39programmercharg
Page 44: www.lutron.comLutron Electronics Co

Lutron EcoSystem Programming - Lutron Lighting Installation ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?