Lutron EcoSystem Programming - Lutron Lighting Installation ...

More documents

Recommendations

Info

24 <strong>EcoSystem</strong>TM ProgrammerSetting Up Scenes for Wall ControlsWall controls can be set up to activate scenes (preset light levels). Adifferent scene can be configured for each button on the control.1 From the Main Menu, tapDevice Setup and thenIR Receiver/Wall Control.2 Read the instructions, thentap to continue.3 Point the programmer at anyIR receiver and tap tobegin communication.4 If all fixtures go to minimumbrightness and a fixtureconnected to a wall controlflashes, tap .5 Scroll to the wall control to beset (its group fixtures will flash).Tap to configure theselected control.6 If fixtures for this control go totheir scene 1 level, tap .7 Select the number of thescene to be set (scene 1matches the first button on thecontrol, scene 2 matches thesecond button, and so on).8 Scroll to the desired fixture(selected fixture will flash).Adjust the scene level up ordown.Repeat for each scene on thecontrol.15789
<strong>Programming</strong> Guide 259 Select Done.10 Select Setup Another Controlto set scenes for another wallcontrol. Or select Done toexit.11 When done, if all fixtures go tohigh level, tap .Repeat this procedure to set thescene levels for each IR receiverand wall control.10
Page 1: EcoSystemTM Programmer | Programmin
Page 4 and 5: 2 EcoSystemTM ProgrammerSetting a B
Page 6 and 7: 4 EcoSystemTM ProgrammerTransmittin
Page 8 and 9: 6 EcoSystemTM ProgrammerLogging InW
Page 10 and 11: 8 EcoSystemTM ProgrammerInformation
Page 12 and 13: ProgrammingYour System3Typical Prog
Page 14: 12 EcoSystemTM ProgrammerAddressing
Page 17 and 18: Programming Guide 158 Scroll to the
Page 19 and 20: Programming Guide 177 Select the da
Page 21 and 22: Programming Guide 1910 Tap the desi
Page 23 and 24: Programming Guide 2110 Depending on
Page 25: Programming Guide 237 For occupant
Page 29 and 30: Setting a Ballast’s High End Trim
Page 31 and 32: Setting a Ballast’s Emergency Lev
Page 33 and 34: Manually Adjusting the Light LevelP
Page 35 and 36: Programming Guide 33Replacing Balla
Page 37 and 38: Resetting a Ballast to Factory Defa
Page 39 and 40: IndexAaddressing the systemaddressi
Page 41 and 42: Programming Guide 39programmercharg
Page 44: www.lutron.comLutron Electronics Co

Lutron EcoSystem Programming - Lutron Lighting Installation ...

Create successful ePaper yourself

Delete template?

Save as template?