Flags displayed on Laboratory, Patient, and Quality Control Reports ...

<strong>Flags</strong> and Codes on Reports<strong>Flags</strong> <strong>displayed</strong> on Laboratory, Patient, and Quality Control ReportsFlag Description Condition Action>DR Above Dynamic Range The result is above the dynamic range for the analyte. Dilute the sample. Refer to the appropriate package insert and assay methodology sheet.SR Above Supplementary Range The result is above the defined supplementary range for the analyte.

<strong>Flags</strong> and Codes on ReportsCode Description Condition ActionODOperator Requested DilutionThe assay was automatically diluted and the result calculated using the operator requested factorreported in the Dil (Dilution) field. The result reported is for the lowest dilution factor reportedwhen multiple dilution factors are requested.No action necessary.OR Outside Range The result is outside the dynamic or supplementary ranges. Check for dynamic or supplementary range flags and follow the recommended actions.PF Prediction Failure The master computer detected an invalid well reading or did not process valid well readings. Check for additional codes and for condition codes that occurred at or near the report print time.RC Reference Consistency The Luminometer or Incubator reference readings for the well are outside specifications.Check the condition codes for related Luminometer conditions and perform the recommendedprocedures.RDReflex DilutedThe assay was automatically diluted and result calculated using the configured dilution factorreported in the Dil (Dilution) field.No action necessary.RE Reagent Expired The assay was processed from an expired reagent pack or signal reagent. Load a new reagent pack or a new signal reagent pack.RP Reflex Processed The assay was automatically reflex processed. No action necessary.RRRecalculated ResultThe result was recalculated using the Recalculate Results function on the Review Results -Review Edit Results screen.No action necessary.SC Spread Check A replicate result exceeded the percentage spread limit for the mean defined for the reagent lot.UC User Calibration The calibration parameters for this assay were entered manually.WT Well Temperature The well wash temperature is outside specifications.Check for additional codes and for condition codes that occurred at or near the time the replicateswere processed. Repeat the assay, sample, or calibration.No action necessary. User calibrations are defined on the Options & Configuration - Review/UserCalibrations screen.Check the condition codes for potential causes and actions; check environmental monitoring for out-ofrangetemperatures.ZS Zero Set Negative derived test result. Check for additional codes and flags.Refer to your VITROS ECi/ECiQ Immunodiagnostic System Operator’s Guide for more detailed information.©Ortho-Clinical Diagnostics, Inc., 2012 ■ VITROS ® is a trademark of Ortho-Clinical Diagnostics, Inc. ■ 100 Indigo Creek Drive ■ Rochester, NY 14626 Part No. J11794_EN 2012-12-07