1996 LRFD Manual for Engineered Wood Construction

TABLE OF CONTENTSChapter/TitlePageChapter/TitlePageNotation ......................................................................................................... iGlossary ...................................................................................................... v1 Introduction .................................................................................. 11.1 General Information1.2 Design Responsibilities1.3 Other Design Considerations1.4 Products Covered in This Manual2 Project Profiles:Case Studies ......................................................................... 112.1 General Information2.2 Commercial/Industrial2.3 Residential/Retail3. Tension Members .......................................................313.1 General3.2 Design3.3 Special Considerations3.4 Checklist: Using Tension MemberSelection Tables3.5 Design Examples4. Compression Members ........................... 354.1 General Information4.2 Design4.3 Special Considerations4.4 Checklist: Using CompressionMember Selection Tables4.5 Design Examples5. Bending Members ................................................... 415.1 General Information5.2 Design for Moment5.3 Design for Shear5.4 Special Considerations5.5 Checklist: Using Joist and BeamSelection Tables7. Mechanical Connectors ........................ 537.1 General Information7.2 Nails, Spikes and Wood Screws7.3 Bolts, Lag screws, Drift Pins, Dowels7.4 Shear Plates and Split Rings7.5 Typical Connection Details7.6 Checklist: Using Connection SelectionTables7.7 Design Examples8. Structural Panels .....................................................798.1 General Information8.2 Design for Moment8.3 Design for Shear8.4 Checklist: Using Structural PanelSelection Tables8.5 Design Examples9. Shear Walls andDiaphragms .............................................................................. 839.1 General Information9.2 Design9.3 Checklist: Using Shear Wall andDiaphragm Selection Tables9.4 Design Examples10. Reference Information .......................... 8910.1 General Information10.2 Applications-Related Information10.3 Other Design InformationAF&PA/ASCE Standard 16-95 ..... 1116. Bending Plus Axial Loads ................476.1 General Information6.2 Design for Moment6.3 Checklist: Using Combined Bendingand Axial Member Selection Tables6.4 Design ExamplesAMERICAN FOREST & PAPER ASSOCIATION